Aleratec DS18 User manual

USER GUIDE

Aleratec

DVD/CD Shredder DS18™

Part No. 240147

www.aleratec.com

Copyright/Model Identiﬁcation

The content of this manual is for informational purposes only and is subject to

change without notice.

manual and the software described within may not be copied, except in the

normal use of the product(s) described within or to make a backup copy.

Aleratec, Inc.

9851 Owensmouth Avenue

Chatsworth, CA 91311 U.S.A.

www.aleratec.com

Aleratec

®

is a registered trademark and DVD/CD Shredder DS18™ is a

trademark of Aleratec, Inc.

Please record the following information to help expedite any warranty claim:

Model No. _______________________________

Date Purchased __________________________________________________

Place of Purchase ________________________________________________

www.aleratec.com

3

Introduction

Thank you for purchasing the DVD/CD Shredder DS18. Please read this User

Guide thoroughly before using this product.

Precautions

Before operating your DVD/CD Shredder DS18, please read the following.

Warning:

• When shredding DVDs or CDs, keep eyes and ngers away from

the feed opening to avoid possible injury.

• Always unplug the shredder prior to moving, cleaning, or emptying

the wastebasket.

• Continuous shredding of form fed computer paper should not

exceed two minutes.

• Do not attempt to repair the shredder yourself.

• Keep the shredder in the OFF position when it is not in use for an

extended period of time.

• Product is not intended for use by children (product is not a toy).

Keep shredder out of the reach of children.

• Avoid touching the document feed opening with hands. Do not

place hands or ngers into shredder opening to avoid serious injury.

• Avoid clothing touching the document feed opening. Keep all

loose articles of jewelry, and other small items away from the feed

opening to prevent injury.

• Avoid hair touching the document feed opening. Keep all loose

articles of jewelry, and other small items away from the feed

opening to prevent injury.

• Keep aerosol products away.

www.aleratec.com

4

Introduction

Key Items

Entry slot for

full size sheet

of paper

Entry slot for

Blu-ray/DVD/CDs

Control Switch

Waste

Receptacle

Note: Choose a Good Location

1. Allow adequate clearance for moving parts.

2. Do not place near heat sources such as radiators or air ducts, or in a place

subject to direct sunlight, excessive dust, mechanical vibration or shock.

3. Good care will help assure maximum product life. Improper operating

environment and misuse may void the warranty.

Entry slot for

Credit Cards

www.aleratec.com

5

Introduction

Unpacking your Shredder

1. Remove all packing materials from the shredder.

2. Mount the 4 wheels at the bottom of the main body.

3. Place the shredder on a at level surface.

4. Place shredder motor on top of the main body.

5. Slide basket in under shredder motor.

Note: DVD/CD Shredder DS18 will operate only when

the basket is properly in place.

Powering Up your Shredder

1. Plug the shredder into a 120V electrical outlet.

2. Place the slide switch in the AUTO position.

3. The power LED will illuminate and the shredder is now ready for

operation.

www.aleratec.com

6

Shredder Operation

This shredder is equipped with an Auto Start/Stop smart sensor, which

allows the unit to automatically start when an item is placed into the feed

opening and stop as soon as the item travels completely through the feed

opening.

Shredder Capacity

• The shredder will shred up to eighteen letter size sheets of 20 lb. bond

paper. When shredding Blu-ray, DVD or CD discs or credit cards, only

insert one piece at a time.

www.aleratec.com

7

Problems and Solutions

Basic Paper Jam

The shredder should automatically eject any minor excess material from the

feed opening. Manually remove any unshredded material from the top of the

feed opening.

Minor Paper Jam

Place the slide switch in the REV position and pull the remaining sheets of

paper out of the feed opening. Remove the unshredded portion of paper from

the top and clear any excess paper shreds from the feed opening.

Major Paper Jam

1. Turn off or unplug the power cord from the AC outlet and wait at least 40

minutes for the thermal overload protection to reset.

2. Plug in the AC power cord and place the slide switch in the AUTO

position. If paper was left inside the feed opening prior to the overload,

place the slide switch in the REV position, grasp the excess paper from

the top, and pull it out. Be careful to not place your ngers near the feed

opening or serious harm could result. Clear any excess paper shreds from

the feed opening. Press the power button. You are now ready to resume

normal shredding.

Paper Jams and Motor Overload Situations

The shredder is equipped with an automatic motor overload protection

circuit. The duty cycle for the shredder is rated for continuous shredding.

Recommended running time at maximum capacity is 10 minutes on and 40

minutes off. The shredder will automatically terminate power if any of the

following abnormal situations occur:

1. Operating the shredder at the maximum eighteen-sheet capacity continuously

for a prolonged period of time, e.g., more than 10 minutes without stopping.

2. Exceeding the shedding capacity, e.g., inserting more than eighteen sheets

of 20-lb paper in one pass, or if the paper is not fed squarely into the feed

opening.

Both abnormal operations may result in the activation of the automatic thermal

motor overload protection circuit, which terminates power to the shredder. A

paper jam could cause the thermal motor overload protection to terminate AC

power to the motor. Never allow the shredder to remain in a jammed condition

with the AC power turned on.

www.aleratec.com

8

Speciﬁcations

Shredding Capacity • 1 Blu-ray, 1 DVD, 1 CD, 1 Credit Card,

or 18 sheets of paper per pass

Shred Type • Cross Cut

Shred Size • 4 x 32 mm

Feed Opening • Paper: 220 mm (8.66 in.)

• Blu-ray/DVD/CD: 123 mm (4.8 in.)

• Credit Card: 57 mm (2.3 in.)

Weight • 12.90 kg (28.44 lbs.)

Dimensions • L: 380 mm, W: 272 mm, H: 640 mm

• L: 14.95 in. x W: 10.71 in. x H: 25.20 in.

Power Requirements • 115 Volt AC, 4.0 Amp

www.aleratec.com

9

Technical Support

After reading this User Guide, if you need additional assistance with this

product, please contact Aleratec Technical Support. Our technical staff will

be happy to assist you, but they may need your help to better assist you.

• Troubles - your questions about the DVD/CD Shredder DS18. Please

provide enough information about your problems so our technical staff

can recreate and diagnose it.

Technical Support Addresses and Phone Numbers

X By e-mail: [email protected]

X By Telephone: 1-818-678-0484

Technical Support Group can be reached 8:00 AM to 5:00 PM, Pacic

Time, Monday through Friday, excluding U.S. holidays.

Please try to call from a phone near your computer system.

X Access is available 24 hours a day, 365 days a year, via:

The World Wide Web at: www.aleratec.com

FAX at: 1-818-678-0483

www.aleratec.com

10

Technical Support FAX Back Form

Aleratec, Inc.

Technical Support Fax Back Form

To: Technical Support Group FAX: 1-818-678-0483

FROM: _____________________FAX: ___________________________

E-MAIL ____________________________________________________

RE: ________________________TEL: ___________________________

DATE: _______________# OF PAGES: ___________________________

I am experiencing the following problems with my DVD/CD Shredder DS18:

_____________________________________________________________

By answering these questions, your problem will be solved more rapidly.

Make copies as necessary. You can reach us electronically at: www.aleratec.

com on the internet.

www.aleratec.com

Notes:

www.aleratec.com

Notes:

Page is loading ...

www.aleratec.com

Notes:

La elección del “prosumidor”

GUÍA DEL USUARIO

Aleratec

DVD/CD Shredder DS18™

Part No. 240147

Page is loading ...

www.aleratec.com

33

Especiﬁcaciones De La Trituradora

Capacidad De Trituración

• 1 Blu-ray, 1 DVD, 1 CD, 1 Tarjeta de Crédito, ó 18

pliegos de papel por vez

Tipo De Trituración

• Corte transversal

Tamaño De Las Tiras

• 4 x 32 mm

Boca De Alimentación

• Papel: 220 mm (8.66 in.)

• Blu-ray/DVD/CD: 123 mm (4.8 in.)

• Tarjeta de Crédito: 57 mm (2.3 in.)

Peso • 12.90 kg (28.44 lbs.)

Dimensiones • L: 380 mm, W: 272 mm, H: 640 mm

• L: 14.95 in. x W: 10.71 in. x H: 25.20 in.

Potencia De Entrada

• 115 Voltios CA, 4.0 Amps

Page is loading ...

Speciﬁcations subject to change without notice.

Les spéciﬁcations peuvent être modiﬁées sans préavis.

Las especiﬁcaciones se pueden modiﬁcar sin previo aviso.

Aleratec, Inc.

9851 Owensmouth Avenue

Chatsworth, CA 91311 U.S.A.

www.aleratec.com

Aleratec DS18 User manual

This manual is also suitable for

Aleratec DS18 User manual

in other languages

Related papers

Other documents