Angelo Decor AD97001 Operating instructions

Hello! I've reviewed the user manual for the Angelo Decor Fountain. This document provides instructions on unpacking, assembling, and setting up the fountain. Key steps include threading the cord correctly, locking the bowl securely, and placing the pump. The manual also stresses the importance of filling it with water to prevent burnout. I'm ready to answer any questions you have about the setup or operation of your new fountain.
What should I do after unpacking the carton?

How much water should I put in the bowl?

What type of outlet should I plug the fountain into?

Thank you for buying an Angelo Decor Fountain!

We hope you will find these instructions helpful in setting up your fountain. If you need more

information to properly care for your fountain, please DO NOT return the unit to place of purchase.

Please visit our web site, www.angelodecor.com, for assistance and warranty information.

First unpack carton carefully, arranging parts safely in your working area.

Cord through standpipe Cord through bowl Cord through pedestal

Then finally in the groove of the base Twist and lock bowl to base Set the pump to desired strength.

Note restrictor for fine Affix outlet into pump Place pump in housing Twist and lock into place

tuning of flow. be sure not to kink hose

Now simply fill with clean water and plug into a grounded GFCI outlet

We recommend keeping bowl 3/4 full of water to avoid pump burnout.