FSR SG-120HW Installation guide

FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207

43984 C-1164

CEILING BOX VIEW FROM TOP

(TOP PANEL SHOWN REMOVED)

KNOCKOUT FOR SURGE

SUPPRESSOR

CEILING BOX VIEW FROM BOTTOM

(CARRIAGE SHOWN IN DOWN POSITION)

SURGE SUPPRESSOR

REMOVE ACCESS PLATE

ON EXTERIOR OF BOX TO

WIRE SURGE SUPPRESSOR

(SHOWN AS HIDDEN LINES)

WIRE DIRECTLY IN PARALLEL WITH INCOMING 15 AMP

120VAC BRANCH CIRCUIT. INCOMING LINE VOLTAGE MUST

NOT EXCEED 120VAC OR SUPPRESSOR WILL BE DAMAGED

AND WARRANTY VOID.

ENSURE THE BRANCH CIRCUIT IS DISCONNECTED BEFORE

INSTALLATION. THIS DEVICE SHOULD BE INSTALLED BY A

QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NATIONAL

AND LOCAL ELECTRICAL CODES AND ALL ENCLOSED

INSTRUCTIONS.

CAUTION:

SG-120HW SURGE SUPPRESSOR INSTALLATION

APPLICATION:

THE SG-120HW CAN BE INSTALLED IN CONJUNCTION

WITH THE CB-12/CB-22/CB-224 SERIES OF CEILING

BOXES, OR ANY OTHER APPLICATION WHERE IT IS

DESIRED TO PROVIDE SURGE PROTECTION OF A

SINGLE 15 AMP 120VAC BRANCH CIRCUIT.

INSTALLATION INSTRUCTIONS:

1. MOUNT SG-120HW TO CEILING BOX AT DESIRED KO

LOCATION. ON CB-12 AND CB-22 MODELS, EITHER OF THE

TWO PROVIDED BRANCH CIRCUIT INPUT KO's MAY BE USED.

ON THE CB-224 MODELS, USE THE KO INDICATED IN THE

DETAIL DRAWING ABOVE.