FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43984 C-1164
CEILING BOX VIEW FROM TOP
(TOP PANEL SHOWN REMOVED)
KNOCKOUT FOR SURGE
SUPPRESSOR
CEILING BOX VIEW FROM BOTTOM
(CARRIAGE SHOWN IN DOWN POSITION)
SURGE SUPPRESSOR
REMOVE ACCESS PLATE
ON EXTERIOR OF BOX TO
WIRE SURGE SUPPRESSOR
(SHOWN AS HIDDEN LINES)
WIRE DIRECTLY IN PARALLEL WITH INCOMING 15 AMP
120VAC BRANCH CIRCUIT. INCOMING LINE VOLTAGE MUST
NOT EXCEED 120VAC OR SUPPRESSOR WILL BE DAMAGED
AND WARRANTY VOID.
ENSURE THE BRANCH CIRCUIT IS DISCONNECTED BEFORE
INSTALLATION. THIS DEVICE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NATIONAL
AND LOCAL ELECTRICAL CODES AND ALL ENCLOSED
INSTRUCTIONS.
CAUTION:
2.
SG-120HW SURGE SUPPRESSOR INSTALLATION
APPLICATION:
THE SG-120HW CAN BE INSTALLED IN CONJUNCTION
WITH THE CB-12/CB-22/CB-224 SERIES OF CEILING
BOXES, OR ANY OTHER APPLICATION WHERE IT IS
DESIRED TO PROVIDE SURGE PROTECTION OF A
SINGLE 15 AMP 120VAC BRANCH CIRCUIT.
INSTALLATION INSTRUCTIONS:
1. MOUNT SG-120HW TO CEILING BOX AT DESIRED KO
LOCATION. ON CB-12 AND CB-22 MODELS, EITHER OF THE
TWO PROVIDED BRANCH CIRCUIT INPUT KO's MAY BE USED.
ON THE CB-224 MODELS, USE THE KO INDICATED IN THE
DETAIL DRAWING ABOVE.
/
