2. BLOTZ
  3. B28-JR-002

BLOTZ B28-JR-002 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Platform Steps B28-JR-002. This document details how to assemble the model using glue, a modelling knife, and optionally pegs or elastic bands. It also describes how to assemble the base, sides, steps and their supports. I'm ready to answer your questions about the assembly process.
  • What kind of glue is needed?
    What tools are needed for assembly?
    Can I use anything to hold pieces in place while the glue dries?
28mm Platform Steps
B28-JR-002
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the base, sides and rear of the steps….
..and glue them together as shown above.
Locate the three step supports.
Glue them into position.
Add each step, alternaing the stone pattern on
them.
The finished steps.
/