Oneida Air Systems AXD000002-DDB Template

The Bracket can be installed

upside down for easier access

to the wall fasteners after

attaching the cyclone (See

Owner’s Manual).

When doing so, rotate this

template 180° so that the level

line is on the bottom.

9-3/4"

82.55 mm

1-1/4"

32 mm

51 mm

Dust Deputy Bagger Wall Bracket Template

#ZBT000002

Drill Here Drill Here

LEVEL THIS LINE

March 17, 2021

The Dust Deputy Bagger Wall Bracket should be mounted to a sturdy, reinforced wall (e.g.

concrete wall, brick wall, wood-framed wall, etc.) Wall anchors can be used if mounting on

drywall. This template indicates the proper drill holes and the full, assembled size of the Wall

Bracket.

Dust Deputy Bagger Wall Bracket Template

The Cyclone can be rotated in 60-degree increments so that the inlet is facing parallel or

perpendicular to the wall. Decide how you want your system oriented during installation to

best meet your shop’s needs.

Cyclone Mounting Positions

Place a mark through the Template at each indicated crosshair (at least two keyway holes from opposite ends), then remove the

Template from the wall. If mounting to a stud reinforced wall, center the template on a stud to utilize the reinforcing slots.

3/4"

19 mm

1-1/2"

38 mm

3-1/4"

83 mm