T: +44 (0)20 8441 0352 F: +44 (0)20 8441 0219 E: [email protected].uk hib.co.uk
Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN
©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the
interest of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.
FI#07 001 R151221 Ver No. 1.0 Jan 2016
Thank you for purchasing this HiB product.
Please read through these instructions carefully and refer back to
them during installation to ensure that your product is fitted safely
and that it retains its high quality finish.
Please retain this leaflet for future reference.
Before installation, ensure that there are no hidden cables or
pipes in the wall.
Chrome Support Brackets
Chrome Support Brackets Art No. 8875 Mounting Points Diagram
N.B. Basin shown below is for illustrative purposes only and
may differ to the basin purchased.
Care Instructions
Do not use abrasives or solvents when cleaning this product.
Wipe o all water spillages as soon as possible using a soft, damp cloth.
Aercare Service
In the unlikely event that this product should fail please contact HiB
customer services, details shown below.
Installation:
1. Attach the rails to the bottom of the basin using a bead of silicone.
Ensure that the rails are in line to the back of the basin by holding the
basin up against a flat surface (see diagram 1). Leave the silicone to
set for 12 hours.
2. Position the basin at the desired height, ensuring that it is straight by
using a spirit level. Mark the position of the fixing brackets using a so
pencil (see diagram 2).
3. Before drilling, ensure there are no hidden cables or pipes
behind the mounting points. Using a masonry drill, drill holes in
the marked positions to a suitable depth. If drilling through tile, use a
ceramic drill bit.
4. Insert wall plugs level with the surface of the wall. If fitting to a tiled
surface, wall plugs should be inserted below the tile surface to avoid
cracking. NB. For plasterboard walls, specialist fixings should be
purchased, available from any DIY or hardware store.
5. Hold the basin in place against the wall and bolt it through the holes
in the brackets into the wall plugs using the coach bolts provided.
For added strength, use washers between the coach bolts and the
bracket (see diagram 3).
6. Apply a bead of silicone around the top and side edges of the basin
(see diagram 4). Leave the silicone to set for 12 hours.
1.
2.
3.
4.
Compatible with:
Delta 8860, Swirl 8870, & Ocean 8780
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
HiB Bellus Datasheet
-
HiB Vantage Operating instructions
-
HiB AEON Fitting Instructions
-
HiB Kingsbury User manual
-
HiB Blend Fitting Instructions
-
HiB Fabrica Fitting Instructions
-
HiB Veles Fitting Instructions
-
HiB Vapor Fitting Instructions
-
HiB LED Underlighting Fitting Instructions
-
HiB Fabrica Fitting Instructions
