Retractor SM Mount • Installation Guide
The Retractor SM modules require a Quad or Triple Bracket for installation in a compatible
enclosure. For installation, see the appropriate enclosure installation guide and see the
Retractor SM Installation Guide for the Retractor. Both are available at www.extron.com.
Retractor SM Mount - Quad
Each Quad Bracket can mount up to two Retractor SMs on either side of a centrally located
Power Module.
2
Cable Cubby 1202
Enclosure
Secure each
Quad Bracket
on two sides with
the included mounting
screws and star washers
(4 places each).
Quad
Bracket
Slide the bracket
into the enclosure
as shown.
1
Retractor SM Mount • Installation Guide (Continued)
Retractor SM Mount - Triple
A Triple Bracket can mount up to three Retractor SMs on either side of a compatible enclosure.
EBP 1200C
Enclosure
Triple
Bracket
1
Insert the triple bracket into the
enclosure as shown above.
2
Use the provided mounting screws
and the star washers to secure
the bracket in place.
NOTE: Optionally, the Triple Bracket can be turned 180 degrees and mounted,
depending on the application need.
68-3160-01
Rev. B 02 18
© 2017-2018 Extron Electronics — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
/
