Facon LED RV Fabric Light Fixture Installation guide

Brand
Facon
Model
LED RV Fabric Light Fixture
Type
Installation guide
E-mail: [email protected]
Website: http://www.Genesis-Light.com
US Headquarter: WaysPride LLC
Manufacturer: Genesis Lighting
RISK OF PERSONAL INJURY-PLESAE READ THESE INSTRUCTIONS
CAREFULLY.FOLLOW ALL INSTALLATION INSTRUCTIONS AND OBSERVE ALL
WARNINGS.
Please read all of the instructions below BEFORE installation
Make sure the "supply" voltage corresponds to the
"rated" product voltage
12 Volts DC
The product MUST be installed by a qualified
electrician in accordance with The National Electrical
Code and corresponding local codes.
If the product is damaged, DO NOT ATTEMPT
INSTALLATION AND DO NOT USE!
INSTALLATION GUIDE
IMPORTANT SAFETY INFORMATION:
Genesis Lighting is a manufacturer focus on providing various
kinds of products for Recreational vehicle / Caravans / Mobile
home industry and Home builder market since early 2006.
This light fixture is designed for 12 Volt DC applications.Perfect to
Use as a Fancy Decor for Bedside Light, Book Reading Light, Chart
Light and Map Lamp, Wall Light and Porch Light.
Excellent Replacement for RV, Caravan, Motorhome, Camper,
Travel Trailer, Boat, Marine, Kitchen, Living Room and Bedroom
You can dim this light easily with a normal 12 Volts dimmer switch.
Recommend "Facon" brand PWM touch dimmer switch.
(An optional dimmer switch is required and not included in the package)
LED Wall Sconce Fabric Light Series
LED RECESSED MOUNT ORDERING INFORMATION:
LED Bulb: BA15D, DC12V
Screws
LED Flush Mount Fixture
Make sure the "supply" voltage corresponds to the
"rated" product voltage 12 Volts DC
The Light will be burn out if wire it to 24 Volts, 36
Volts or 120 Volts.
LF101T‐005 Round 71/2'' 43/4'' 61/2'' Y
LF131T‐005 Square 71/2'' 43/4'' 61/2'' Y
DimmableModel# Shape Lenght Width Height
1. Remove 2 screws and then take down the mounting
plate from back of light fixture.
2. Install the mounting plate to the wall with 2 screws.
Use a level (not included) to
ensure that the mounting plate is level on the wall.
3. Turn off the electricity, connect the wire according to
instrustions.
White wire=Negative(-), Black wire=Positive(+)
4. Slide fixture onto mounting plate making sure tha the
screw holes
on the fixture are aligned with screw holds on mounting
plate.
Install the fixture to the wall with 2 scerws
5. Install the LED bulbs into the light fixture.
6. Turn on the electricity and enjoy the brightness.
Press the switch to turn on the light, Press again to turn
it off.
2
Installation Instructions
B
1
2
3
LED Bulb: BA15D, DC12V. Cross Reference: 1142, 1004,
1076, 1130, 1158, 1176, 1178
You can replace the LED bulb easily if you want a different
color temperature or wattage.
If the bulb is not working,recheck wiring and installation.
If all wiring is correct and the fixture still does not work,
the LED bulb must be replaced.
LED Bulb:
BA15D, DC12V
4
Q: Does this light flicker when they are dimmed on a dimmer switch?
A: No flicker. It is dimmable. You can dim this light easily with a normal 12 volts PWM
dimmer switch.(An optional dimmer switch is required and not included in the
package if you want to dim the light)
Q: What is the color temperature of this light? cool white? warm white?
A: It is 3200K warm white soft bright light.
Q: Are these lights have switch?
A: Yes, a build-in on&off switch at the side of the light fixture base. You can control
this light with this on&off switch convenience.
Q: Do they include the bulb? What type/model bulb do these use?
A: Yes, the light fixture comes with a LED light bulb in it.
LED Bulb: BA15D, DC12V. Cross Reference: 1142, 1004, 1076, 1130, 1158, 1176, 1178.
Q: Will these work with 24 volts instead of 12v?
A: No. it works on 12Volts DC system only. please wire it to a proper transformer if
you need to use it with 24 volts.
1. If the light too dim and runs to too hot on the lens. It is the voltage higher
than 12volts. Please don't wire this light to 24volts, 36 volts or 110 volts power
supply.
2. If the light can not turn on, check the polarity of the 2 wires. Are they
reversed?
3. If the light can not turn off by additional wall switch. check the polarity of
the wires on the dimmer.
4. If the light flicker frequent. check the max wattage of your vehicle power.
There is too much load. Use lower wattage lamps or reduce the quantity of
lamps.
E-mail: [email protected]
Website: http://www.Genesis-Light.com
US Headquarter: WaysPride LLC
Manufacturer: Genesis Lighting
LED Recessed Puck Light Series
Frequently Asked Questions and Answers:
Troubleshooting:
Technical support available at [email protected]
LIMITED ONE YEAR WARRANTY
If within one(1) year from the date of purchase, the product fails due to a defect in
material or workmanship,
WaysPride LLC(Genesis Lighting) will repair or replace it free of charge.
WaysPride LLC will not be liable for incidental or consequential damages to
purchases, or any other party.
For any loss, damage, injury or expense of any kind or nature caused directly or
indirectly by the product or the failure of the product to operate properly.
Warranty service is available by mailing postage prepaid to WaysPride LLC.
17 McMillan way KH0135 Newark De 19713.
A valid copy of original invoice and return merchandise authorization ( or RMA) are
required for all warranty services.
Q: Is the shade replaceable? Will standard shades work?
A: Yes, the shade is replaceable. But sorry that we don't sell the shade separately. If
you want to buy the shade in other place, please make sure the size should be: Dia: 4
3/4'' x H 5 3/4''
Q: Will the led survive the voltage fluctations in an rv (11-18 volts)?
A: the voltage for this light is 12V DC, the led survive the voltage fluctation around
10-15 volts.
Q: Can I hook the wires up to a 12 volt 10 amp cigarette lighter?
A: Sure, the light work on any 12v DC power source.
  • Page 1 1
  • Page 2 2

Facon LED RV Fabric Light Fixture Installation guide

Brand
Facon
Model
LED RV Fabric Light Fixture
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents