Way Basics WB-4CUBE-2-EO Operating instructions

Brand
Way Basics
Model
WB-4CUBE-2-EO
Type
Operating instructions

This manual is also suitable for

Important
THIS SIDE UP
7 8
Align top horizontal zBoard to unit
and press down firmly.
Enjoy building possibilities!
21 3 4
6
Carefully remove the 3M
protective layer from adhesive
(adhesive shown in yellow).
Align middle horizontal zBoard
(has grooves on top and
bottom) and press down firmly.
Place alignment pins
in vertical zBoards.
Align vertical middle
zBoard to horizontal zBoard
and press down firmly.
Insert backboards into
grooves.
Align vertical middle
zBoard to horizontal zBoard
and press down firmly.
Insert backboards into
grooves.
Align vertical side zBoards with
grooves facing the backboard.
Align vertical side zBoards
with grooves facing the
backboard.
5
4 Vertical Side zBoards
groove on 1 side
24 Pins
2 Vertical Middle zBoards
groove on 2 sides
4 Backboards
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
1 Top zBoard, 1 Bottom zBoard
Groove on 1 side
1 Middle zBoard
Groove on 2 sides
Included
4 CUBBY
Help and Comments www.waybasics.com/contact
version 042017
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.
  • Page 1 1

Way Basics WB-4CUBE-2-EO Operating instructions

Brand
Way Basics
Model
WB-4CUBE-2-EO
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents