Euri Lighting ET8-2140-17 Installation guide

Euri Lighting
Brand
Euri Lighting
Model
ET8-2140-17
Type
Installation guide

This manual is also suitable for

INSTALLATION GUIDE
MODEL #: ET8-2140-17 / ET8-2150-17
©2019. Euri Lighting | A Division of IRTRONIX Inc. All Rights Reserved
THIS PRODUCT MAY NOT BE COMPATIBLE WITH ALL BALLASTS, FOR MORE INFORMATION ABOUT BALLAST COMPATIBILITY PLEASE VISIT: WWW.EURILIGHTING.COM
Linear Series | T8 Class
4 ft. LED Tube
READ ALL WARNINGS AND INSTRUCTIONS PRIOR TO INSTALLING THE T8 RETROFIT LAMPS
TO ENSURE SAFETY AND PROPER OPERATION
WARNINGS
• Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt
installation. Contact a qualified electrician in accordance with the National Electrical Code and relevant local code. Install this kit only in the
luminaires that have the construction features and dimensions shown in the photographs and/or drawings.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
• Risk of electric shock – Do not use where direct exposed to water. Direct replacement for the following lamps only: 32W/ 48T8.
• Risk of fire – If the LED tube exhibits undesirable operation (Buzzing, flickering, etc.), immediately turn off power, remove LED tube from
luminaire and contact manufacturer.
• Risk of fire – If installing this lamp in a pre-heat luminaire, remove the automatic starters from their holders before installing lamp.
• Risk of fire – Do not install this LED tube in a pre-heat luminaire. This LED tube operates on magnetic or electronic ballasts.
If lamp does not light when the luminaire is energized, remove LED tube from luminaire and contact LED tube manufacturer or qualified electrician.
INSTALLATION INSTRUCTIONS
1. Switch-off power to luminaire.
2. Remove diffuser (if provided).
3. Remove existing fluorescent lamp(s) from luminaire. Note: Verify that the fluorescent tube type is listed on the LED lamp label.
4. Install LED lamp (one for each fluorescent lamp removed, ensure pins are firmly seated in lamp holders).
5.Switch on power to luminaire and reattach diffuser (if provided).
STEP 1 STEP 2 STEP 3
A
B
Open difuser cover
for access.
Rotate fluorescent tube to remove then insert new LED tube and rotate to lock into place.
Repeat sequence for each tube. Close cover when complete.
For customer service please call us at 1-888-743-5766
Office Hours: 8:00 a.m. – 5:00 p.m. PST Monday-Friday
Questions?
LED
Tube
Plug & Play
  • Page 1 1

Euri Lighting ET8-2140-17 Installation guide

Euri Lighting
Brand
Euri Lighting
Model
ET8-2140-17
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents