Design House 519694 Installation guide

Design House
Brand
Design House
Model
519694
Category
Racks
Type
Installation guide

This manual is also suitable for

AJAX 1LT CEILING MOUNT
ASSEMBLY/INSTALLATION INSTRUCTIONS
WARNING: Risk of Fire. Min 75ºC supply conductors. Consult a qualied electrician to ensure correct
installation.
Turn off the main power at the circuit breaker before installing the xture, in order to prevent possible
shock.
#519686
Customer Service 1-800-558-8700
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualied electrician.
Remove the xture and the mounting package from the box and make sure that no parts are missing by
referencing the illustrations on the installation instructions.
Phillips screwdriver.
CAUTION
GENERAL
TOOLS REQUIRED
ASSEMBLY AND INSTALLATION
ASSEMBLY AND INSTALLATION
(CONT.)
Please read carefully and save these instructions, as you may need them at a later date.
Turn off the power at fuse or circuit breaker.
Turn on the power at fuse or circuit breaker.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
JUNCTION BOX
MOUNTING SCREWS
WIRE NUTS
CROSS BAR
GROUND SCREW
FIXTURE SCREWS
FIXTURE
SCREW HOLES
BALL NUTS
IRON RACK
SOCKET RING
BULB (not included)
IRON RACK (01)
DECORATIVE NUTS
#519694
1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS
and the FIXTURE SCREWS. Attach the CROSS BAR to the JUNCTION BOX using (2) MOUNTING
SCREWS.
2. Make wire connections with WIRE NUTS:
A - Connect the black wire from Fixture to the black supply wire.
B - Connect the white wire from Fixture to the white supply wire.
C - Attach the xture ground wire to the CROSS BAR with the green GROUND SCREW. Then
connect it to the supply ground wire with a WIRE NUT. Carefully tuck wires back into the JUNCTION
BOX.
3. Attach the FIXTURE to the CROSS BAR through SCREW HOLES as shown, and secure it with
BALL NUTS.
4. Attach the IRON RACK to the FIXTURE and secure it with SOCKET RING.
5. Install BULBS (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
6. Attach the IRON RACK (01) to the IRON RACK as shown, and secure it with DECORATIVE NUTS .
A
C
B
Item # 519686 (AJAX 1LT SEMI FLUSH CM GAL)
Item # 519694 (AJAX 1LT CEILING MOUNT BRZ)
  • Page 1 1

Design House 519694 Installation guide

Design House
Brand
Design House
Model
519694
Category
Racks
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents