Sargent EC20 User Instructions

Brand
Sargent
Model
EC20
Category
Motorcycle Accessories
Type
User Instructions
AUX OUT +VE (Grey / Red)
LEISURE BATTERY -VE
VEHICLE
BATTERY -VE
2
4
3
LEISURE
BATTERY
VEH (Vehicle Batt +VE)
LEIS (Leisure Batt +VE)
15A
Fuse
5
PANEL CONNECTOR
AUX (OUT)
COM (Charger IN)
Aux output
controlled by
the AUX
switch
1
-VE INPUT (Black -for Voltmeter only)
BATTERY
CHARGER
(Brown / Red)
GROUND (-VE IN)
15A
LEISURE BATTERY +VE (Brown / Blue)
15A
Common
Negative
Ground
block
Fused
Feed from
Vehicle
battery
Both battery supplies and the charger supply should be fused at 15A.
As per EN1648, the leisure battery fuse should be placed as close as possible to the battery, but not
inside the battery compartment. The wire from the battery to the fuse should have an extra layer of
insulation / protection.
The battery select switch is used to select which battery will be used (and which battery will be
charged if a charger is fitted and it is operating). The switch also has a central off position.
You should use wiring of an appropriate cross sectional area to suit the circuit design.
Document subject to change without prior notice, please see www.sargenttld.co.uk for updates and
additional information.
Specification
9V to 14.5V DC operation
2x 15A battery inputs
1x 10A switched outputs
Digital voltmeter with on / off switch
Panel dimensions 130mm x 80mm
Cut out size 102mm x 55mm
Hole centres 117mm
Sargent Electrical Services Ltd.
EC20 Control Panel -Installation Instructions
Issue 01 21/6/13
VEHICLE BATTERY +VE (Brown / Green)
15A
Double
insulation
over feed
to fuse
  • Page 1 1

Sargent EC20 User Instructions

Brand
Sargent
Model
EC20
Category
Motorcycle Accessories
Type
User Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents