Page is loading ...
LP60 MI/C ACCESS CONTROL READER
Range: IP ACCESS CONTROL
Series:
Installation Connection Programming Use
Datasheet n°603-0058A
www.castel.fr
Page 1 / 2
PRESENTATION
Product reference: 910.0097 (LP60MI/C)
The LP60MI/C is 13,56MHz contactless card readers (tags
BPM32/C, BPM34/C, BR01/C and BP32DES) that interfaces with
other devices in the VDIP range equipped with a reader interface
(VDLECT, VD4LECT). They will read the unique serial numbers of
MIFARE® and MIFARE DESFIRE (ISO 14443A standard) tags.
CONNECTION
The reader has an 8-point connector for connecting it to the VDIP system's reader interface (connection to 6-point
terminal block, 2 point for buzzer and detection of tearing).
Maximum distance between the reader and the VDLECT: 100 m with 6/10 cable + shield
Connect one end of the cable shield to earth.
The LP60MI/C is powered by the VDLECT or VD4LECT. Position the reader interface power supply selection switch
to 12 V.
+
Mains power supply voltage selection
+12V power supply
Ground
Green led control
Red led control
Data / Data “0”
Clock / Data “1”
USE
Operation of lights
Blue light indicating the proper functioning of the reader.
Red light indicating default
Green light indicating when access is granted
Operation of the buzzer
Indicates the reading of a badge with a short beep
The buzzer can be activated by grounding the connector “ buzz “.
ACCESS CONTROL READER LP32/C
Environmental protection:
Dispose of this product in compliance with environmental preservation regulations.
Datasheet n°603-0058A
www.castel.fr
Page 2 / 2
CASTEL: Z.I. Saint Lambert des Levées - 49412 SAUMUR Cedex - France
Tel.: +33 2.41.40.41.40 - Fax: +33 2.41.40.41.49
Non-binding photos and document. In constantly striving for improvement, the CASTEL company reserves the right to make any modifications it considers necessary.
Detection of tearing
Digital output (open collector) reports uplift the reader.
Reading badges
The reading distance varies with the type of tag used:
↘ Tag BPM32/C: up to 8cm.
↘ Key Ring BPM34/C: up to 4cm.
↘ Remote control BR01/C: up to 3cm.
↘ Tag BP32DES: up to 4cm
INSTALLATION
Fixation
Directly on the wall or in a standard wall box, screw the support by two screws.
If possible, screw the magnet to the wall to also detect the snatching of the support.
The cache including the reader is then fitted onto the support.
Magnetic
Disassembly
Use a screwdriver and push up the two tabs under the cache.
TECHNICAL SPECIFICATIONS
Compliance with European standards
EN 301-489-17 V2.1.1 for CEM
EN 302-291-2 for radio
EN 50364 for health
EN 60950-1 : 2006 for security
Mechanical characteristics
IP54 protection as per EN 60529
Dimensions: 80mm X 80mm X 15mm
Weight: 70g
General electrical characteristics
Power supply: 12Vdc
Consumption: 50mA
CASTEL Wiegand 34 bits type interface
Service temperature: -20° / 60°C
Storage temperature and hygrometry: frost
free <85%RH
/
