2. Nucraft
  3. Tavola Standing Height and Credenza

Nucraft Tavola Standing Height and Credenza Installation Instructions Manual

  • I have reviewed the provided installation instructions for the Tavola Standing Height Table and Credenza. The document details the steps required for assembly and glass installation, including the necessity of two people for the process and the use of suction pods for glass handling. I'm ready to answer any questions you have about the installation procedures outlined in this document.
  • How many people are required for assembly?
    What tools are needed for assembly?
    What should be done before installing the glass top?
Tavola Standing Height and Credenza Installation Instructions
Rev. 10/2014
Before Beginning Installation
Read through the entire instruction thoroughly
A minimum of 2 people are required for this
assembly
These instructions reflect typical assemblies; They
may not match your specific configuration
Required Tools and Hardware
Level
PODS For Glass Handling (where
applicable)
Tavola Standing Height Table
Tavola Standing Height Exploded
1.Frame
2.Side Panels
3.Top 1
3
2
Tavola Credenza
Tavola Credenza Exploded
1.Frame
2.Side Panels
3.Top
4.Case 1
3
2
4
Tavola Standing Height| 8
Step 1
Setting Glass
Locate credenza in its final
position
Make sure and level
Remove the cardboard spacers
Using suction pods, set the top
glass in place.
/