Focal Point ID+ 3.5" x 3.5" Downlight FLC33D / LC33 Installation guide

Brand: Focal Point

Model: ID+ 3.5" x 3.5" Downlight FLC33D / LC33

Type: Installation guide

This manual is also suitable for

ID+ 3.5" x 3.5" Wall Wash FLC33W / LC33

IS0760 REV. B 2022 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 4

non-emergency - thermally protected, non-ic

id+ 3.5" square housing

FLC33D | FLC33W

Luminaires must be installed by a qualiﬁed electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

LUMINAIRE MUST BE INSTALLED PRIOR TO DRYWALL CEILING.

ALL GRID LUMINAIRES MUST BE SECURED TO STRUCTURE ABOVE.

emergency - remote test switch, non-ic ic/cp

Flc33d | Flc33w

Flc33d | Flc33w Flc33d | Flc33w

key

power oFF

power on

level

attention

see additional

instructions

WALL WASH ORIENTATION

WALL

FOR ASTM E-283 AIR-TIGHT

COMPLIANCE, SEAL IC HOUSING/

RO TRIM WITH SILICONE CAULKING

BETWEEN THE EDGE OF THE COLLAR

AND CEILING MATERIAL. SEAL ALL

ADDITIONAL HOLES IN HOUSING

WITH ALUMINUM TAPE.

2.64”

.50”

3.16”

10.61”

tall cone

dnt

keep shaded area Free From oBstruction aBove ceiling

optional

Bar hangers sold separately

short cone

dns

SUPER

SHORT CONE

dss

IS0760 REV. B 2022 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 4

Fixtures must be installed by a qualiﬁed electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

GRID - 1/2" CONDUIT & CLIP (BY OTHERS)

24x4

4 1/8”4 1/8”

ceiling cutout

GRID - BAR HANGERS (SOLD SEPARATELY)

x2 3 4a2

4b multiple luminaires only

IS0760 REV. B 2022 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 3 of 4

Fixtures must be installed by a qualiﬁed electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

DRYWALL - BAR HANGERS

make electrical connections

METAL STUDS

WOOD STUDS

minimum ceiling thickness: 1/2"

maximum ceiling thickness: 1-1/2"

2a x4 x4

5114

adjust test switch until

canopy is Flush with ceiling BATTERY UNIT CONNECTOR INSIDE

0.75"

7.301"

±0.58"

4.125”

5.246

±0.58"

3.191

±0.58"

EMERGENCY - REMOTE TEST SWITCH ABOVE CEILING ACCESS REQUIRED

release

test switch

From Bracket

prior to

installation

Contractor is responsible for adequately reinforcing walls and/or ceilings to support ﬁxture weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls and/or

ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC

is prohibited.

DRIVER SERVICE

1 2

EM- MOUNTING HEIGHT

SEE BATTERY MANUFACTURER

INSTRUCTIONS

emergency maximum mounting height:

downlight: 20.7'

wallwash: 15.6'

DO NOT MATE BATTERY

UNIT CONNECTOR

UNTIL INSTALLATION