GV-Loop Through Card
The GV-Loop Through Card is designed to take the video signal directly from the GV
Video Capture Card, without internal device processes, and then split it into 16
signals while maintaining video quality.
1
2
1-8 D-Type Video Cable x 1
GV-Loop Through Card x 1
Packing List
2 x 40-pin connector
2 x 15-pin D-type ports
1 x 40-pin connector
16 channels
130 x 98 (mm) / 5.12 x 3.86 (in)
Specifications
40-Pin Ribbon Cable x 1
9-16 D-Type Video Cable x 1
3
4
GV Video Capture Card
Video Out 1~8
(Loop Out)
Video Out 9~16
(Loop Out)
40-Pin
Ribbon Cable
4
GV-Loop Through Card
1
2
3
9-16 D-Type
Video Cable
1-8 D-Type
Video Cable
No. 3
No. 2
No. 1
Note:
1. For the No. 2 video out, an extra D-type extension card is required.
2. Choose either No. 1 or No. 2 for video out. Using both at the same time may
cause video degradation.
3. Only connect GV series cards, such as GV Video Capture Card, GV-DSP Card
or GV-Hybrid DVR Card, to No. 3. Other devices are prohibited.
GV-System Interface
Output interface
Input Signal
Dimensions (W) x (H)
GV-Loop Through Card
No. 1: Video OUT
No. 2: Video OUT
No. 3: Video IN/OUT
(IN for GV Video Capture Card, OUT for GV-DSP Card or GV-Hybrid DVR Card.)
IN
OUT
40-Pin Ribbon Cable with Four 10-Pin Headers x 1 (Only for
GV-2004 or GV-2008 Card)
5
2009.3.23
Connections with Two Video Capture Cards
In the computer where two GV Video Capture Cards are installed, up to two GV-Loop
Through Cards can be installed. Use the supplied Ribbon Cable to connect the GV-Loop
Through Card to the desired GV Video Capture Card. The picture below demonstrates the
connections of two GV-Loop Through Cards with two GV Video Capture Cards.
GV-Loop
Through Card
GV Video Capture Card
GV Video Capture Card
Video Out
1~8
(Loop Out)
Video Out
9~16
(Loop Out)
40-Pin
Ribbon
Cable
GV-Loop Through Card
Video Out
17~24
(Loop Out)
Video Out
25~32
(Loop Out)
/
