Doc. 6140223 Rev.-
1/9
Doc. 6140223 Rev.-
2/9
Wireless Thermostat Installation
1) Determine the thermostat location.
a. Approximately 5ft above the floor
b. On a wall for best line of sight to the PTAC Unit (see illustration 1)
Illustration 1
2) Installation Materials Required
EZ Touch IR Wireless Thermostat / base
a. Four (4) AA alkaline batteries (included)
b. Four (4) screws and anchors (included)
c. #0 Phillips screw driver
d. The EZ touch thermostat, the remote receiver and its harness make
part of kit # 6040824
Control board (pre-installed in the PTAC unit)
1) Infrared receiver (to be installed in the PTAC’s room enclosure)
2) Infrared receiver harness (to be connected to control board)
Doc. 6140223 Rev.-
3/9
3) Detach the thermostat base as shown, by removing the two bottom screws
Picture 1
Picture 2
BOTTOM
SCREWS
LOCATION
Doc. 6140223 Rev.-
4/9
4) Secure the thermostat’s base to the wall using the four (4) screws and
anchors supplied
Picture 3
Picture 4
Doc. 6140223 Rev.-
5/9
5) Open the latch, insert the four (4) supplied batteries, secure the latch
Picture 5
Picture 6
Doc. 6140223 Rev.-
6/9
6) Anchor the thermostat back to the base and secure it using the two (2) small
bottom screws
Picture 7
Picture 8
Doc. 6140223 Rev.-
7/9
INFRARED RECEIVER INSTALLATION
INTRODUCTION
The EZ Touch IR receiver will be required when the PTAC unit has been installed
inside an enclosure that does not allow direct line of sight between the digital
controls and the wireless thermostat.
INSTRUCTIONS
1) If required, drill a 5/8” diameter hole on the front cover, approximately 3
inches below the top, or the top panel of the enclosure, (See illustration 1)
2) Insert the EZ Touch IR remote receiver through the 5/8” diameter hole and
push it in so it will lock in to place
5
/
8” dia. hole
EZ Touch
IR Receiver
Doc. 6140223 Rev.-
8/9
INFRARED RECEIVER INSTALLATION
3) Connect the EZ Touch IR receiver (picture 10) to the 10 ft EZ Touch IR
receiver extension harness (picture 9) that must be attached to the control
board inside the PTAC unit (see location on picture 11)
Picture 9
(EZ Touch IR receiver harness)
Picture 10
(EZ Touch IR receiver harness)
Doc. 6140223 Rev.-
9/9
Picture 11
(Control Board)
4) The blank off piece shown in picture 12 may be attached over the control pad
location to instruct users to use the EZ touch IR on the wall.
Picture 12
(PTAC Unit Digital Controls Blank off)
INFRARED RECEIVER INSTALLATION
EZ Touch IR
receiver harness
connector
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
McQuay Suite Incremental Installation & Maintenance Data
-
Amana DT01A User manual
-
Amana DT01G Operating instructions
-
Trane PTEE150 User manual
-
McQuay Suite II Installation & Maintenance Data
-
-
McQuay Incremental PDNS Series Installation & Maintenance Data
-
Amana DT01G Installation guide
-
-
EMI VPAC/VPHP 09-24 Installation & Operation Manual