DAP 09153 Operating instructions

Step-by-Step Instructions

1. Select the right size PrestoPatch

: Measure the size of the hole in the wall to

determine the appropriate PrestoPatch

or compare the drawing on the

packaging

2. Stencil the hole to by using the styrofoam template to trace a circle around the

hole in the drywall leaving some space

3. Cut out the hole, on the outside edge of the circle, with a utility knife or drywall

saw

4. Clear away any loose paper or debris left in the opening with your hand

5. Fit the PrestoPatch

in the hole to ensure that it fits properly before putting joint

compound on

6. Make sure to use joint compound because spackle is not made to hold the

integrity of the wall per manufacturer’s suggestion, we are currently

assessing this.

7. Lay the plug paper side down on a flat surface and apply a generous amount of

compound to the drywall circle edge and the drywall paper

a. Fireguard Only –

Apply the joint compound to the inside edge of the hole in the wall in

addition to step G. Apply a thin coat of compound to the back of the

fireguard plug to maximize the fire rating

8. Insert the circle into the hole and smooth out the drywall paper by using a putty

knife to move excess compound under the drywall paper towards the outer

edge

9. Apply compound over the surface of the drywall paper in a circular motion

10. Once compound has dried, sand smooth, prime and paint.