DAP 09153 User manual

Type
User manual

DAP 09153 is a simple, structural, and invisible solution to permanently repairing holes in drywall. It can repair holes up to 3 7/8” or 6 7/8” in standard ½” drywall. The product includes a pre-cut drywall circle with oversized taping paper attached and a foam template.

Possible use cases:

  • Repairing holes in drywall caused by nails, screws, or other fasteners
  • Repairing holes in drywall caused by doorknobs or other objects hitting the wall
  • Repairing holes in drywall caused by water damage or other environmental factors

Key features:

  • Pre-cut drywall circle with oversized taping paper for easy installation

DAP 09153 is a simple, structural, and invisible solution to permanently repairing holes in drywall. It can repair holes up to 3 7/8” or 6 7/8” in standard ½” drywall. The product includes a pre-cut drywall circle with oversized taping paper attached and a foam template.

Possible use cases:

  • Repairing holes in drywall caused by nails, screws, or other fasteners
  • Repairing holes in drywall caused by doorknobs or other objects hitting the wall
  • Repairing holes in drywall caused by water damage or other environmental factors

Key features:

  • Pre-cut drywall circle with oversized taping paper for easy installation
1
Technical Bulletin
2400 Boston Street, Suite 200, Baltimore, Maryland 21224
Phone: 410-675-2100 or 800-543-3840
Revised: 01/04/13
DAP
®
Presto Patch
Wall Repair
Permanent drywall repair
Restores structural integrity of wall
Makes repairs invisible
Time saving solution
Pre-cut for easy installation
Porous drywall paper for permanent repair
Packaging: Product includes: Pre-cut drywall with drywall paper cover, Styrofoam stencil
Color: not applicable
UPC Number: 070798091559, 070798091573
Manufactured For:
Manufacturer: DAP Products Inc., 2400 Boston St., Suite 200, Baltimore, Maryland 21224
Usage Information: Call 1-888-DAP-TIPS or visit dap.com & click on "Ask the Expert".
Order Information: 800-327-3339
Fax Number: 410-558-1068
Product Description:
DAP
®
Presto Patch
is a simple, structural and invisible solution for permanently repairing holes in drywall.
This product repairs up to 3 7/8” or 6 7/8” holes in standard ½” standard drywall. DAP
®
Presto Patch
includes a pre-cut drywall circle with oversized taping paper attached and a foam template.
Suggested Uses:
For use with standard drywall. Not for use with lath or plaster. Do not install DAP
®
Presto Patch
in
temperatures below 45°F (7°C) or above 85°F (30°C).
Performance Characteristics:
Repairs holes up to 3 7/8” wide or 6 7/8” wide, depending on size of DAP
®
Presto Patch
Porous paper allows joint compound through to strengthen bonding
Provides a permanent repair and restores the wall to its original integrity
2
Surface Preparation & Application:
Suggested Additional Supplies: ± ½ pint of joint compound (not spackling), drywall saw, 6” putty knife,
medium and fine sandpaper, and pencil.
1. Center the foam template provided around the damaged area, and trace the circle.
2. With a drywall saw, cut along the outside of traced circle. Do not cut deeper than the ½” drywall patch,
in order to avoid any electric, gas, plumbing or framing behind the wall.
3. Test fit Presto Patch™ in the hole, and enlarge the hole if necessary.
4. Lay Presto Patch™ paper side down and apply generous amount of joint compound on the paper and
along edge of drywall circle.
5. Insert Presto Patch™ into hole, being careful not to push through the wall.
6. Use a putty knife from center of the plug and squeeze the excess joint compound toward the outer edges.
7. Once paper is flat on the surface, apply a generous amount of compound and spread into a thin layer
covering the entire patch. Let compound dry as recommended by manufacturer.
8. Sand using medium grit and finish with fine, then prime and paint.
NOTE: Paper may wrinkle, but flattens when dry.
Physical & Chemical Characteristics:
Material: ½” thick drywall with either 3 7/8” or 6 7/8” diameter and porous drywall paper
Shelf Life: unlimited as long as kept dry (keeping away from high humidity)
Clean Up & Storage:
Wash hands and tools with warm soap and water. Dry joint compound must be sanded or scraped away.
Safety:
Cutting or dry sanding during application may result in the generation of dust which may irritate eyes, nose,
throat or upper respiratory. Do not breathe dust. Minimize sanding through good application techniques. Use
with adequate ventilation. If needed, wear a NIOSH approved dust mask. Follow dust mask manufacturer’s
directions for use. Wearing appropriate gloves and safety glasses is recommended. Follow manufacturer’s
instructions when using cutting tool and joint compound.
Satisfaction Guaranteed:
If product fails to perform when used as directed, DAP will provide a replacement product or sales price refund.
Call 1-888-DAP-TIPS, with your sales receipt and product container available, to arrange for warranty
fulfillment. DAP will not be liable for incidental or consequential damages.
  • Page 1 1
  • Page 2 2

DAP 09153 User manual

Type
User manual

DAP 09153 is a simple, structural, and invisible solution to permanently repairing holes in drywall. It can repair holes up to 3 7/8” or 6 7/8” in standard ½” drywall. The product includes a pre-cut drywall circle with oversized taping paper attached and a foam template.

Possible use cases:

  • Repairing holes in drywall caused by nails, screws, or other fasteners
  • Repairing holes in drywall caused by doorknobs or other objects hitting the wall
  • Repairing holes in drywall caused by water damage or other environmental factors

Key features:

  • Pre-cut drywall circle with oversized taping paper for easy installation

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI