Commercial Electric MB-51310 User manual

Brand: Commercial Electric

Model: MB-51310

Category: Flat panel accessories

Type: User manual

Commercial Electric MB-51310 is a wall mount component shelf that provides a sturdy and convenient way to store and display your audio/video components, as well as other items. The tempered glass shelf has a weight capacity of 20 lbs. (9.1 kgs), making it suitable for housing a variety of equipment. The shelf can be easily mounted to a wall using the included hardware, which is suitable for mounting to walls made of masonry, solid concrete, or wood studs covered with drywall.

MB-51310

WALL MOUNT COMPONENT SHELF

********

Table of Contents

Table of Contents .......................................................2

Safety Information .....................................................2

Warranty.....................................................................2

Pre-Installation ..........................................................3

Installation .................................................................5

Safety Information

Before you begin, make sure you carefully read and

understand the instructions in this manual. Please follow

the instructions in the order presented in this manual and

observe all warnings and cautions.

WARNING: A Warning alerts you to the possibility of

serious injury or death if you do not follow the instructions.

This wall mount has been tested to support equipment

with a weight up to 20 lbs (9.1 kgs).

WARNING: This wall mount is intended for use only

with the maximum weights indicated. Use with products

heavier than the maximum weights indicated may result in

collapse of the mount and its accessories causing possible

injury. This mount has been tested to support 20 lbs. (9.1

kgs). Do not exceed this weight.

WARNING: Observe all safety measures at all times

during the installation of this product. Use proper safety

gear and tools during the installation process to prevent

physical injury.

WARNING: Check that the mount is secure and safe to

use at regular intervals (at least every 3 months).

WARNING: Failure to provide adequate structural

strength for this component can result in physical

injury and/or damage to equipment. It is the installer’s

responsibility to make sure the structure to which

this component is attached can support the combined

weight of the equipment and all attached hardware and

components.

WARNING: This product was designed to be installed

installation may cause damage or serious injury.

WARNING: This product should only be installed by

someone with good mechanical ability who has basic

building experience and fully understands this manual.

WARNING: If mounting to wood wall studs, make sure

the mounting screws are anchored into the center of the

WARNING: Always use an assistant or mechanical lifting

equipment to safely lift and position the equipment.

WARNING:

tighten. Over-tightening can cause damage to the product.

This greatly reduces the holding power.

WARNING: This product is intended for indoor use only.

Using this product outdoors could lead to product failure

and personal injury.

CAUTION: A Caution alerts you to the possibility of

damage to or destruction of the equipment if you do not

follow the corresponding instructions.

CAUTION: Do not install on a structure that is prone to

vibration, movement or chance of impact. Doing so could

result in damage to the mounting surface.

Warranty

The manufacturer warrants that it will replace or repair this item, free of charge, at the manufacturer’s sole

discretion, should it prove defective in materials or workmanship.

If a claim is made under this warranty, the mount should be returned, freight prepaid, with the original purchase

receipt to your dealer.

This warranty does not apply to:

□ Normal wear and tear

□ Friction damage

□ Coating defects

□ Defects caused by loosened screws, nuts, or bolts

□ Improperly mounting the bracket to the wall

□ Improperly installing the bracket to the equipment

□ Failure to properly follow installation

instructions

□

by the manufacturer

□ Loading beyond permitted load

□ Intentional misuse

Contact the Customer Service Team at 1-877-527-0313 or visit www.HomeDepot.com.

3 HOMEDEPOT.com

Please contact 1-877-527-0313 for further assistance.

Pre-Installation

TOOLS REQUIRED (NOT INCLUDED)

Power

drill

5/32 in. (4 mm)

wood drill bit or

5/16 in. (8 mm)

masonry drill bit

Phillips

screwdriver

Level Pencil

Stud

Tape measure

Safety

glasses

E GC D

HARDWARE INCLUDED

NOTE: Hardware not shown to actual size.

NOTE: The hardware included is suitable for mounting to walls made of masonry, solid concrete, or wood studs covered with drywall.

www. HomeDepot.com.

Part Description Quantity

AA Lag bolt 2

BB Nylon anchor 2

CC Washer 2

PACKAGE CONTENTS

Silicone pad

Allen key

Part Description Quantity

A Tempered glass shelf 1

B Bracket 1

C Screw 1

D Conical washer 1

Silicone pad 4

PLANNING WALL PLACEMENT

CAUTION: Ensure the wall you select is a weight-bearing wall. Failure to observe this precaution can result in serious physical injury

and/or property damage. Consult a professional installer or contact customer service if you have any questions.

When selecting a wall to mount your audio/video components, keep the following in mind:

□ Select a place with easy access to power outlets, cable input sources, and connections for speakers and

accessories.

□

□ Select a weight-bearing wall. The wall must be able to safely support four times the combined load of the

equipment and all attached hardware and components.

ENSURING WALL STABILITY

Carefully inspect the wall area you have selected. Examine the wall surface before you begin drilling.

WARNING: Do not drill near electrical wiring and water pipes.

□ For concrete walls, check for damaged or loose concrete and do not drill in those areas.

□ For masonry wall, never drill into the mortar between blocks.

□ For wood studs, locate the wall studs and drill in the center of the stud.

9.84"(250mm)

13.58"(345mm)

0.2"(5mm)

Pre-Installation

5 HOMEDEPOT.com

Please contact 1-877-527-0313 for further assistance.

Installation

Installing the bracket (wood stud)

If you are installing this mounting system in masonry (concrete), proceed to step 2.

CAUTION: Avoid drilling near electrical wiring and water

pipes. The mounting system must be attached to a weight

bearing wall and must be installed directly onto the center

of the wood studs. Failure to observe all safety precautions

can result in serious physical injury and/or property

damage. Consult a professional installer or call customer

service if you have any questions.

CAUTION: Tighten the screws so that the bracket is

damage the screws, greatly reducing the holding power.

CAUTION: Wood studs must be no smaller than 2 x 4

in. in size.

□ Use a commercially-available stud ﬁnder to locate the stud centers in the wall. Studs are usually

spaced 16 in. apart.

□ Use the bracket (B) as a template to mark the installation holes. Use a level to ensure the bracket is level.

□ Use a 5/32 in. (4 mm) wood drill bit to drill 2 in. (50 mm) pilot holes.

□ Attach the bracket (B) to the wall using the lag bolts (AA) and washers (CC).

CAUTION: Avoid drilling near electrical wiring and water

pipes. The mounting system must be attached to a weight

bearing wall. Failure to observe all safety precautions can

result in serious physical injury and/or property damage.

Consult a professional installer or call customer service if

you have any questions.

CAUTION: Do not drill in mortar between masonry blocks

or into loose concrete. Never drill into hollow masonry block.

□ Use the bracket (B) as a template to mark the installation holes. Use a level to ensure the bracket is level.

□ Use a 5/16 in. (8 mm) masonry drill bit to slowly drill 2.2 in. (55 mm) pilot holes.

□ Insert anchors (BB) into the holes. Ensure the anchors are completely ﬂush to the concrete surface even

if covered by a layer of joint compound or other material.

□ Attach the bracket (B) to the wall using the lag bolts (AA) and washers (CC).

Installation (continued)

Installing the bracket (concrete/masonry walls)

Attaching the silicone pads to the bracket

□ Attach the silicone pads (E,F) to the bracket (B) as shown using the adhesive tape on the back of

the silicone pads.

Installing the tempered glass shelf

□

7 HOMEDEPOT.com

Please contact 1-877-527-0313 for further assistance.

Installation (continued)

Attach the tempered glass shelf (A) to the bracket (B) using the screws (C), conical washers (D) and

Allen key (G).

Questions, problems, missing parts? Before returning to the store,

call Commercial Electric Customer Service

8 a.m. - 7 p.m., EST, Monday-Friday, 9 a.m. - 6 p.m., EST, Saturday

1-877-527-0313

HOMEDEPOT.COM

Retain this manual for future use.

Commercial Electric MB-51310 User manual

Brand: Commercial Electric

Model: MB-51310

Category: Flat panel accessories

Type: User manual

Download PDF

report

Commercial Electric MB-51310 User manual

Commercial Electric MB-51310 User manual

Related papers

Other documents