3. The status LED flashes blue to indicate a successful connection.
Accessing Bluetooth settings on mobile phones varies for
each phone, to find the information for your phone, please refer to
its user manual.
Note:
5.4 Hands-free Calling
Whilst connected to your mobile phone, the EP650 will act as a
hands-free system for calls.
Press to pick up or hang up a call. Press and hold for 2
seconds to reject the incoming call..
During a call, double press to transfer the call between the
headphones and your mobile phone.
- For computers
Note:
1. Enable the Bluetooth function on your computer.
2. Select “Devices and Printers” from the Control Panel and click
“Add a Device”.
3. Select “EP650” from the available devices, the system will install
the driver automatically.
For Windows XP and Vista, a third-party Bluetooth driver is
needed (not included).
4.The status LED flashes blue to indicate a successful connection.
5.If the EP650 is not automatically set as your output device, select
“Sound” from the control panel then highlight the EP650 and select
“Set Default”.
When switched on, the EP650 will automatically reconnect to
the last paired Bluetooth device if it is in range.
Note:
5.3 Remote Control
The EP650 is able to control the music playing on either a
mobile phone or a computer with a Bluetooth connection.
Press “ ” to pause or resume playing music.
Press “ ” or “ ” to increase or decrease the volume.
Press “ ” or “ ” to select the previous or next track.
Note: Music playing control is only compatible with devices
that support A2DP, please refer to your devices user manual
for its A2DP compatibility.
5.5 Audio-In
5.6 Wired Use USB Cable
To use the EP650 as a pair of wired headphones, use a 3.5mm audio
cable to connect the EP650 to your source device. Once the audio
cable is connected to the EP650, the device automatically switches
to wired mode.
When the EP650 connects to a computer via USB cable, it will be
recognized as a USB audio device. The system will install the driver
automatically. You can select “Sound” from the control panel then
highlight “Headphone” and select “Set Default” to make EP650 as
the default audio output and input device. In USB headphone mode,
EP650 is being charged all the time.
6. Charging
When the power is low, the status LED flashes red.
To charge the EP650, connect the micro USB lead to the device’s
power socket, and the other end of the USB cable to a powered
USB port.
-6-
-5-
English