2. Sunricher
  3. SR-2828

Sunricher SR-2828, SR-2833TS User manual

  • Hello! I've reviewed the user manual for the Sunricher 09.283TS.04215 Remote Controller. This document details how to pair the remote with an RF receiver, control brightness, and use the touch on/off function. It also highlights it's compatibility with universal series RF receiver. I'm ready to answer any questions you have about using this device.
  • What is the power supply for the remote controller?
    How many RF receivers can be paired with one remote controller?
    How do I pair the remote with the RF receiver?
RF Single Color Remote Controller 09.283TS.04215
Note:Before the first use, please remove the protective film on the battery.
Function introduction
Important: Read All Instructions Prior to Installation
Output RF signal
Operation Frequency
868/869.5/916.5/434MHz
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 141x35x8.5mm
Front side
Back side
• Control 1 zone of RF receiver
• Single color controller
• Compatible with universal serie RF receiver
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Safety & Warnings
Power Supply 6V(2xCR2025 battery)
Brightness slider:
slide touch to adjust brightness between
1-100% with 256 levels smooth dimming
range
Touch to turn on/off
2xCR2025 battery
Pair with RF receiver
Step 2:
three times continuously to set it into pairing status
Click the “Learning Key” button on RF receiver or re-power on the receiver
Note: one receiver can be paired with max 8 remote controls.
Learning Key
RF LED Receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 3:Touch the slider, LED lights connected with the RF receiver flicker once means
the receiver is paired with the remote successfully.
/