2. LNC
  3. A03390

LNC A03390, A03391, A03392, A03394, A03395 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the LNC A03390 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Weareheretohelp:[email protected]
www.lnchome.comPage: ‐1‐/4
ItemNumber:A03395
WARNING(Toreducetheriskoffire,electricshock,orinjurytopersons):
1. Wesuggestinstallationbyalicensedelectrician.
2. Pleasereadtheinstructioncarefullyandsaveitasyoumayneeditatlatertime.
3. Beforeyoustart,NEVERattemptanyworkwithoutshuttingofftheelectricityuntiltheworkisdone.A).Gotothemain
fuse,orcircuitbreaker,boxinyourhome.Placethemainpowerswitchinthe“OFF”position.B).Placethewallswitch
inthe“OFF”position.
4. Mountingsurfaceshouldbeclean,dry,flat,strongenoughand1/4”largerthanthecanopyonallside.Anygapsbetween
themountingsurfaceandcanopyexceeding3/16”shouldbecorrectedasrequired.
5. Makesurethattheceilingorwallcanstandtheweightofthelampbeforefixture.
6. Makesurethevoltageyouareusingis120V.Themaximumwattageis60Wperbulb.
7. Keepthelampawayfromacidicandbasicobjectsincaseofdamagingthesurfaceofthelamp.
8. Whenreplacingbulb,youshouldturnofforunplugthelampandyoumustwaituntilitiscoolasbulbsgethotquickly.
9. Thesafetyinstructionsappearinginthismanualarenotmeanttocoverallpossibleconditionsthatmayoccur.Itmust
beunderstoodthatcommonsense,cautionandcaremustbeusedwithanyelectricalproducts.
IMAGEFORFINISHEDPRODUCT：
Weareheretohelp:[email protected]
www.lnchome.comPage: ‐2‐/4
TOOLSREQUIRED(NOTINCLUDED):
Beforedoingassemblyandinstallationpleasepreparetheneededtoolsasbelowpicture
PARTSTYPE&QTYINCLUDING:
(B) Mounting plate (1)
(C)Green ground screw (1)
(E) Stud (4)
(F) Back plate (1)
(G) Socket cap (4)
(H)Glass(4)
ACCESSORIES&QTYENCLOSED:
(A)Plastic wire connector (3)
(D) Mounting screw (2)
ASSEMBLY&INSTALLATIONINSTRUCTIONS:
1. Carefullyremovethefixturefromthecartonandcheckthatallpartsand
accessoriesareincludedasshownintheaboveillustration
2. Turnoffpower
3.1)Gentlyunscrewthestuds(E)frombackplate(F)byscrewdriver
2)Carefullyremovethemountingplate(B)frombackplate(F)
Weareheretohelp:[email protected]
www.lnchome.comPage: ‐3‐/4
4.1)Carefullypullthewiresfromoutletboxthroughmountingplate(B)
2)Attachthemountingplate(B)tooutletboxwithmountingscrews(D)
5.Makewireconnections
Connectwiresasbelowwiresconnectingshown.TAKENOTEOFYOURWIRECOLOROFFIXTURE,NEVERCONNECT
WIRETOGROUNDWIRE
ConnectgroundwireaccordingtobelowchartConnectwiresaccordingtobelowchart
Twistplasticwireconnectoruntilwiresaretightlyjoinedtogether,wrapeachconnectorwithapprovedelectricaltapeand
carefullytuckallwiresintotheoutletbox
6.Gently push the fixture to wall, and carefully adjust the fixture
to make the holes on back plate (F) and mounting plate (B)are to be
aligned ,then thread the screws （E）to secure the fixture in
place
byscrewdriver
Weareheretohelp:[email protected]
www.lnchome.comPage: ‐4‐/4
7. 1) Install bulb (not included) (Please do not exceed
the maximum capacity recommended on the socket.)
2) Carefully position glasses on socket caps
8.
Checkeverythinginstalledproperly,thenyoucouldturnonthelight.
CLEANING
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as
scouring pads or powders, steel wool or abrasive paper.
ORDERINGPARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture
can be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.
/