LNC A03396 Installation guide

Type
Installation guide

LNC A03396 is a lighting fixture designed for indoor use. It features two glass shades that can accommodate bulbs with a maximum wattage of 60W each. The fixture requires 120V power and should be installed by a licensed electrician. For safety, the power should be turned off before any installation or maintenance work is carried out. The fixture comes with all the necessary parts and accessories, including mounting screws, wire connectors, and a ground screw. It is recommended to clean the fixture with a soft cloth and avoid using abrasive materials.

LNC A03396 is a lighting fixture designed for indoor use. It features two glass shades that can accommodate bulbs with a maximum wattage of 60W each. The fixture requires 120V power and should be installed by a licensed electrician. For safety, the power should be turned off before any installation or maintenance work is carried out. The fixture comes with all the necessary parts and accessories, including mounting screws, wire connectors, and a ground screw. It is recommended to clean the fixture with a soft cloth and avoid using abrasive materials.

Weareheretohelp:[email protected]
www.lnchome.comPage: ‐1‐/4
ItemNumber:A03396
WARNING(Toreducetheriskoffire,electricshock,orinjurytopersons):
1. Wesuggestinstallationbyalicensedelectrician.
2. Pleasereadtheinstructioncarefullyandsaveitasyoumayneeditatlatertime.
3. Beforeyoustart,NEVERattemptanyworkwithoutshuttingofftheelectricityuntiltheworkisdone.A).Gotothemain
fuse,orcircuitbreaker,boxinyourhome.Placethemainpowerswitchinthe“OFF”position.B).Placethewallswitch
inthe“OFF”position.
4. Mountingsurfaceshouldbeclean,dry,flat,strongenoughand1/4largerthanthecanopyonallside.Anygapsbetween
themountingsurfaceandcanopyexceeding3/16”shouldbecorrectedasrequired.
5. Makesurethattheceilingorwallcanstandtheweightofthelampbeforefixture.
6. Makesurethevoltageyouareusingis120V.Themaximumwattageis60Wperbulb.
7. Keepthelampawayfromacidicandbasicobjectsincaseofdamagingthesurfaceofthelamp.
8. Whenreplacingbulb,youshouldturnofforunplugthelampandyoumustwaituntilitiscoolasbulbsgethotquickly.
9. Thesafetyinstructionsappearinginthismanualarenotmeanttocoverallpossibleconditionsthatmayoccur.Itmust
beunderstoodthatcommonsense,cautionandcaremustbeusedwithanyelectricalproducts.
IMAGEFORFINISHEDPRODUCT
Weareheretohelp:[email protected]
www.lnchome.comPage: ‐2‐/4
TOOLSREQUIRED(NOTINCLUDED):
Beforedoingassemblyandinstallationpleasepreparetheneededtoolsasbelowpicture
PARTSINCLUDING:
(A) Mounting plate (1)
(B) Green ground screw (1)
(E) Back plate (1)
(F) Stud (4)
(G) Socket ring (2)
(H)Glass(2)
(I)Socket(2)
(J)Fixture(1)
ACCESSORIESENCLOSED:
(C) Plastic wire connector (3)
(D) Mounting screw (2)
ASSEMBLY&INSTALLATIONINSTRUCTIONS:
1. Carefullyremovethefixturefromthecartonandcheckthatallpartsand
accessoriesareincludedasshownintheaboveillustration
2. Turnoffpower
3. Makeassembly&installation
StepA1:Unscrewthestuds(F)frombackplate(E)
thengentlyremovemountingplate(A)
Weareheretohelp:[email protected]
www.lnchome.comPage: ‐3‐/4
StepA2:Carefullypassfromoutletboxthroughmountingplate(A)
Securebackplate(A)tooutletboxwithmountingscrews(D)
StepA3:Makewireconnections
Connectwiresasbelowwiresconnectingshown.TAKENOTEOFYOURWIRECOLOROFFIXTURE,NEVERCONNECT
WIRETOGROUNDWIRE
ConnectgroundwireaccordingtobelowchartConnectwiresaccordingtobelowchart
Twistplasticwireconnectoruntilwiresaretightlyjoinedtogether,wrapeachconnectorwithapprovedelectricaltapeand
carefullytuckallwiresintotheoutletbox
StepA4:Putthebackplate(E)onthemountingplate(A)andadjustthe
backplate(E)tosecuretheholestobealigned then
secureitwithstuds(F)
StepA5:
Place the glasses(H)over sockets(I)then secure with the
retaining socket rings (G)
Installbulb(Notincluded.Pleasedonotexceedthe
maximumcapacityrecommendedonthesocket.)
Weareheretohelp:[email protected]
www.lnchome.comPage: ‐4‐/4
4. Checkeverythingisinstalledproperly,thenyoucouldturnonthelight.
CLEANING
To clean, wipe fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel
wool or abrasive paper.
ORDERINGPARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture
can be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

LNC A03396 Installation guide

Type
Installation guide

LNC A03396 is a lighting fixture designed for indoor use. It features two glass shades that can accommodate bulbs with a maximum wattage of 60W each. The fixture requires 120V power and should be installed by a licensed electrician. For safety, the power should be turned off before any installation or maintenance work is carried out. The fixture comes with all the necessary parts and accessories, including mounting screws, wire connectors, and a ground screw. It is recommended to clean the fixture with a soft cloth and avoid using abrasive materials.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI