GATCO 1562 Installation guide

Brand: GATCO

Model: 1562

Type: Installation guide

This manual is also suitable for

GATCO 1562 is a decorator mirror designed to enhance your bathroom's aesthetics. It features a lustrous finish that can be easily maintained with soft damp cloths. The mirror is easy to install and can be mounted on various surfaces, including drywall and tile. It comes with all the necessary hardware, including Molly bolts, tile anchors, and screws. The mirror is also adjustable, allowing you to customize its position to your liking.

• Philips head screwdriver

• Tape measure

• Level

• Safety glasses

10. Place the two upper bracket

bases (c1) on the studs (B) and

position the two upper

cylinder-shaped bracket parts

(c2) on the top edge of the

mirror. Align the respective

bracket parts (c1 and c2) over

the stud (B). (Fig. 8)

5. Unscrew the screws (a)

from the Molly bolts (A).

Molly bolts will remain in the

wall. (Fig. 3)

Caution: Two people are required to safely install this mirror. The mirror will break if dropped. Take extra precautionary measures

to ensure a secure grip on the parts.

Caution: Molly bolts are for dry walls only. Use tile anchors for tile surfaces. (not included)

INSTALLATION INSTRUCTION

9. Rest the mirror (F) on the

lower mirror brackets (C).

(Fig. 7)

1. Once the location of the

mirror has been determined,

mark the positioning of the

four mounting studs and their

screw holes with a pencil. Use

a measuring tape and a level

for accuracy. (Fig. 1)

2. Drill 5/16 in. pilot holes

into the wall where the Molly

bolts will be inserted using an

electrical drill.

4. Use an electrical

screwdriver to tighten the

screws. This will collapse the

Molly bolts (A) tightly to the

wall. (Fig. 2)

8. Tighten the set screws (D)

with Allen wrench (E). Make

sure that the opening of the

groove is facing up. (Fig. 6)

PREPARATION

Tools Required for Assembly: (not included)

• Pencil

• Electrical drill with 5/16 in. drill bit

6. Place the stud (B) over the

Molly bolts. Insert the screws

(a) back through the bracket

and the Molly bolts, and then

tighten firmly with Philips

head screwdriver. (Fig. 4)

7. Secure the two lower mirror

brackets (C) to the wall. First,

place the mirror bracket’s base

(c1) on the stud (B) and then

place the cylindar-shape part

(c2) on the base. (Fig. 5)

3. Tap Molly bolts (A) into the pilot holes using a hammer.

11. Tighten the set screws (D)

with Allen wrench (E). (Fig. 9)

12. Tighten the set screws (G)

in each of the four mirror

brackets with Philips head

screwdriver. Tighten until just

snug – do not over tighten.

(Fig. 10)

• Hammer

CARE AND MAINTENANCE

To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.

GENERAL INSTALLATION INSTRUCTION

LATITUDE 2 DECORATOR MIRROR

Fig. 2

Side View

Fig. 3

Fig. 4

Side View

Fig. 9

Fig. 5

Fig. 6

Side View

Fig. 10

Fig. 8

Fig. 7

Fig. 1

GATCO 1562 Installation guide

Brand: GATCO

Model: 1562

Type: Installation guide

This manual is also suitable for

Download PDF

report

GATCO 1562 Installation guide

This manual is also suitable for

GATCO 1562 Installation guide

Related papers

Other documents