GATCO 825MX Installation guide

Type
Installation guide
PREPARATION
Tools Required for Assembly: (Not included)
Pencil
Electrical drill with 5/16 in. drill bit
Philips head screwdriver
CAUTION:
Molly bolts are for drywalls only. Use Tile Anchors for Tile surfaces. (not included)
INSTALLATION INSTRUCTIONS
Tape measure
Level
Safety glasses
1
CARE AND MAINTENANCE
1.
2.
3.
4.
5.
6.
7.
GENERAL INSTALLATION INSTRUCTIONS
CURVED SHOWER ROD
Fig. 2
Side View
Fig. 6
Side View
Fig. 5
Fig. 7
Side View
Fig. 8
Fig. 4
Use Level
Fig. 3
Bath Enclosure
Top View
Fig. 1
5/16”
Measure mounting Location: Hold shower rod up to
desired position, ensuring that rod is level and mark
position on each wall by lightly tracing around the shower
rod escutcheon(A). (Fig.1&2)
Disassemble Shower Rod by unscrewing escutcheons (A)
and remove mounting brackets(B). (Fig.3)
Center a mounting bracket (B) in marked circle from Step1
and mark mounting screw positions. Check for levelness
before proceeding. Repeat on opposite side. Make sure the
flat sides of the mounting bracket are horizontal as
shown.(Fig.4)
Drill 5/16” holes as marked from step3 and insert Molly
Bolts (C) until flush with the wall (drywall installation
only). Using a drill with a Phillips head bit, tighten screws
of the Molly Bolts. This will collapse the Molly Bolt
tightly to the wall. Repeat on opposite side. (Fig.5)
Unscrew the screws from the Molly Bolt leaving the Molly
Bolt in place. Repeat on opposite side. (Fig.6)
Place mounting brackets (B) over Molly Bolts (C) and
insert screws. Fasten the screws through mounting bracket
holes. (Fig.7)
Install one end of Shower Rod (D) by inserting it into
mounting bracket (B), ensuring proper fit and fasten
Shower Rod escutcheon (A) by screwing onto the mounting
bracket. Expand rod and repeat for other side. (Fig.8)
To maintain the beautiful luster finish, please use soft damp
cloths when cleaning and never use any cleaning solvents.
  • Page 1 1

GATCO 825MX Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI