2. Interlogix
  3. TVD-SNB-BB Back Box

Interlogix TVD-SNB-BB Back Box Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Interlogix TVD-SNB-BB Back Box Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
. P/N 1072180-EN • REV B • ISS 05DEC16
TVD-SNB-BB Back Box Installation Instructions
Description
Weight: 485 g (1.07 lb.)
Dimensions: 182 x 99.5 x 42 mm (7.1 × 3.9 × 1.6 in.)
Supported wall mounts: TVD-SNB, TVD-M2-WM
Figure 1: Dimensions of the back box
Figure 2: Top view
Accessories
The back box is shipped with:
• Expansion screws (4 pieces)
(mm)
• HM 6 x 22 mm screws (4 pieces with flat and lock
washers)
• G 3/4 (one pre-installed on the back box, two in the
package box)
(mm)
Installation
1. Mount the back box to the wall with the four expansion
screws supplied.
A.
B.
2. Install the swan neck bracket to the back box using the
four HM 6 x 22 mm screws and lock washers supplied.
截面
2 / 2 P/N 1072180-EN • REV B • ISS 05DEC16
Regulatory information
Manufacturer
Interlogix.
2955 Red Hill Avenue, Costa Mesa, CA 92626
5923, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, The Netherlands
Certification
Copyright
© 2016 United Technologies Corporation.
Interlogix is part of UTC Climate, Controls &
Security,a unit of United Technologies
Corporation. All rights reserved.
Trademarks and
patents
Trade names used in this document may be
trademarks or registered trademarks of the
manufacturers or vendors of the respective
products.
Contact information
For contact information, see www.interlogix.com or
www.utcfssecurityproducts.eu.
/