3M Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Refill User guide

Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Refill
3M
Brand
3M
Model
Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Refill
Type
User guide

This manual is also suitable for

SEALING PITS AND FISSURES
Adper
™
Prompt
™
L-Pop
™
Self-Etch Adhesive
1 of 2
1
2
3
4
Preparation:
• Thoroughly clean teeth to remove plaque and debris from enamel
surfaces and fissures. Rinse thoroughly with water and dry. Note:
Do not use any cleaning medium that contains oils or fluoride.
• Prepare adhesive according to dispensing instructions
(see opposite side).
• Brush adhesive onto surface to be
sealed; massage for 15 seconds
applying moderate pressure. Do not
shorten this time. Proper bonding
will not occur if the solution is
simply applied and dispersed.
• Use a gentle stream of air to
thoroughly dry the adhesive to a thin
film. A second layer is not required
for bonding sealants.
• Apply a light-cured sealant. (Note:
Adper Prompt self-etch adhesive is
not indicated for self-cure sealants)
• Light-cure the sealant and adhesive
together with a halogen, LED or
plasma light for the amount of time
specified to cure the sealant.
SEALING PITS AND FISSURES
2 of 2
3M ESPE Technical Hotline 1-800-634-2249 70-2009-3551-1
Please refer to instructions for more detailed information 44-0007-3459-8
as well as precautionary and warranty information. © 3M 2003
3M, ESPE,Adper, Prompt, and L-Pop are trademarks of 3M or 3M ESPE AG. Used under license in Canada.
4
Adper
™
Prompt
™
L-Pop
™
Self-Etch Adhesive
5
6
3
Dispensing:
• Squeeze the material from the red
reservoir into the yellow (middle)
reservoir.
• The middle reservoir will expand
indicating proper transfer of fluid.
• Carefully fold back the red reservoir
until it meets the flat face of the
yellow reservoir.
• Keep the red reservoir tightly
squeezed while bending the
package to prevent the material
from flowing back.
• Squeeze the liquid from the yellow
reservoir into the green reservoir.
• Apply a churning or spinning
motion to the applicator for 5
seconds to mix the adhesive and
fully coat the applicator tip.
• A lightly yellow-tinted
applicator tip indicates proper
activation.
  • Page 1 1
  • Page 2 2

3M Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Refill User guide

Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Refill
3M
Brand
3M
Model
Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Refill
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents