2. 3M
  3. Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Economy Pack,41928 500ct
Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Economy Pack,41928 500ct

3M Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Economy Pack,41928 500ct, Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Refill User guide

  • Hello! I am an AI chatbot trained to assist you with the 3M Adper™ Prompt™ L-Pop™ Self-Etch Adhesive Economy Pack,41928 500ct User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
SEALING PITS AND FISSURES
Adper
™
Prompt
™
L-Pop
™
Self-Etch Adhesive
1 of 2
1
2
3
4
Preparation:
• Thoroughly clean teeth to remove plaque and debris from enamel
surfaces and fissures. Rinse thoroughly with water and dry. Note:
Do not use any cleaning medium that contains oils or fluoride.
• Prepare adhesive according to dispensing instructions
(see opposite side).
• Brush adhesive onto surface to be
sealed; massage for 15 seconds
applying moderate pressure. Do not
shorten this time. Proper bonding
will not occur if the solution is
simply applied and dispersed.
• Use a gentle stream of air to
thoroughly dry the adhesive to a thin
film. A second layer is not required
for bonding sealants.
• Apply a light-cured sealant. (Note:
Adper Prompt self-etch adhesive is
not indicated for self-cure sealants)
• Light-cure the sealant and adhesive
together with a halogen, LED or
plasma light for the amount of time
specified to cure the sealant.
SEALING PITS AND FISSURES
2 of 2
3M ESPE Technical Hotline 1-800-634-2249 70-2009-3551-1
Please refer to instructions for more detailed information 44-0007-3459-8
as well as precautionary and warranty information. © 3M 2003
3M, ESPE,Adper, Prompt, and L-Pop are trademarks of 3M or 3M ESPE AG. Used under license in Canada.
4
Adper
™
Prompt
™
L-Pop
™
Self-Etch Adhesive
5
6
3
Dispensing:
• Squeeze the material from the red
reservoir into the yellow (middle)
reservoir.
• The middle reservoir will expand
indicating proper transfer of fluid.
• Carefully fold back the red reservoir
until it meets the flat face of the
yellow reservoir.
• Keep the red reservoir tightly
squeezed while bending the
package to prevent the material
from flowing back.
• Squeeze the liquid from the yellow
reservoir into the green reservoir.
• Apply a churning or spinning
motion to the applicator for 5
seconds to mix the adhesive and
fully coat the applicator tip.
• A lightly yellow-tinted
applicator tip indicates proper
activation.
/