Hearth and Home Technologies Ventilation Hood TS345 User manual

Hearth and Home Technologies
Brand
Hearth and Home Technologies
Model
Ventilation Hood TS345
Type
User manual

This manual is also suitable for

HeatilHearth & Home Technologies Inc. • TS345 Square Termination Cap • 31446 Rev E • 04/07
1
TM
TM
Models:
TS345
Square Termination Cap
Installation
Instructions
This chimney termination cap has been tested for use with specifi c Hearth & Home Technologies Inc. fi replaces. Check with
your local building code agency before you begin installation to ensure compliance with local codes, including the need for
permits and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarifi cation of
any of the instructions contained here, contact your Hearth & Home Technologies Inc. dealer. For the dealer nearest you,
please visit www.hearthnhome.com
Note: An arrow (¨) found in the text signifi es change in content.
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
CAUTION
13-1/4 in.
(337 mm)
18 in.
(457 mm)
16-1/4 in.
(413 mm)
22 in.
(559 mm)
23-1/8 in.
(587 mm)
16"
Minimum
Field
Constructed
Shroud
Maximum
Height of 16"
Open
Top
Only
18¾"
Minimum
Roof Chase
3" air space
from bottom of
shroud to top
of chase
Dimensions for a Field Constructed Shroud
Figure 1
Figure 2
Fire Risk
• Intended for use with a metal chase
top.
Use of combustible materials will cause a
fi re hazard.
WARNING
¨
¨
¨
Hearth & Home Technologies Inc. • TS345 Square Termination Cap • 31446 Rev E • 04/07
2
Roof Line
Last section of pipe
must stop between the
distances given below
2” above top
of chase
3” below top
of chase
1. Remove screws
and screen
2. Remove baffle
Figure 3
Figure 4
Installation
• Install the chase top.
• Place the inner slip section into the inner section of the uppermost chimney section. Slip the outer slip section over the
outer section of the uppermost chimney section. Press the termination assembly down until the fl anges contact the chase
top.
• Using the holes in the fl anges as guides, drill 1/8” diameter holes in the chase top. Lift the cap, place waterproof sealant
on the bottom of the fl anges, push the fl ange onto the chase top and secure with the four screws provided in the fastener
package. Place a small dab of waterproof sealant over each screw head to ensure a leak tight top.
• When a fi eld constructed decorative surround is installed around this termination assembly, the shroud must meet or
exceed the minimum dimensions shown in Figure 2. The chase must measure a minimum of 18¾” x 18¾”.
• For chimney cleaning, remove the four screws and the screen from the top of the cap. Lift out the baffl e system. Clean
baffl e, screen and chimney, and reinstall everything. See Figure 4.
Note: The last chimney section must be located within 2”
above or 3” below the chase top. See Figure 3.
Note: To protect the cap against the effects of corrosion, we recommend
that the termination caps be painted with rust resistant paint.
¨
  • Page 1 1
  • Page 2 2

Hearth and Home Technologies Ventilation Hood TS345 User manual

Hearth and Home Technologies
Brand
Hearth and Home Technologies
Model
Ventilation Hood TS345
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents