Page is loading ...
20-zone
Expander
NXG-220
www.interlogix.com.au
Interlogix
®
Series / Expanders
Features
• 20 zone expander (double layer module)
• Double end-of-line resistor support
• Separate box tamper input
• DIN-rail mountable
• Removable terminals
• Firmware upgrade via USBUP ash tool or via
• DLX900 over the network
• EN50131-3 CLASS II GRADE 3
Increasing zone capability
The NXG-220 adds by default 20 supervised hardwired zone inputs to
the Hills Reliance XR Pro panel.
Installation
The module is DIN-rail mountable and can be added into the control
panel enclosure or can be installed remotely. The bus input, as well as
each zone input is wired on a removable terminal block allowing easy
wiring and maintenance.
Programming
The NXG-220 does not need specic programming. Enrolling the
module and programming the zones is done from the control panel.
The rmware of the module is upgradeable remotely via DLX900 or
locally using the USBUP ash device.
NXG220 -DS-191030-1
Interlogix Australia
National Sales Enquiries
1300 361 479
10 Ferntree Place
Notting Hill, Victoria 3168
T: +61 3 239 1200
W: www.interlogix.com.au
Specications
Supply voltage (typical)
12 Vdc
Current consumption (typical) 30 mA
On-board zones 20
End-of-line resistor value
Double end-of-line
3.3K - 6.6K; 4.7K - 9.4K; 4.1K - 8.2K
Tamper input normally closed
Operating temperature 0 to 49°C
Storage temperature -34°C to 60°C
Maximum humidity 85% relative humidity non-condensing
Dimensions (L x W x H) 135 x 80 x 65mm
Weight 0.180 kg
Ordering information
Part No. Description
NXG-220 xGen 20-zone expander
NXG-208 xGen 8-zone expander
20-zone expander
NXG-220
UTC Fire & Security Australia Pty Ltd trading as Interlogix. Specications subject to
change without notice. All trademarks are the property of their respective owners.
© 2019. All rights reserved.
/
