Logik L20TFH19 User manual

Type
User manual
Safety Warnings
For your continued safety and to reduce the risk of injury or electric shock, please
follow all the safety precautions listed below. Read all instructions carefully before
using the unit and keep them for future reference.
Retain the manual. If you pass the unit onto a third party, make sure to include this
manual.
This appliance is intended for indoor household use and similar applications such
as:
– farm houses and by clients in hotels, motels and other residential type
environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.
Make sure your home voltage matches the voltage displayed on the appliance. If
you are not sure, contact an electrician.
Do not kink or wrap the mains cable and plug around the appliance, as this
may cause the insulation to weaken and split, particularly where it enters the
appliance.
Ensure the mains cable is fully extended before use and arrange it so that it is not
in contact with any part of the appliance.
Do not pull on the mains cable. Never move, carry or hang the appliance by the
mains cable.
Always position the appliance with the mains plug in an accessible position and
avoid the use of an extension cable as it may overheat and create a potential re
risk.
The appliance must have a minimum 50 cm clearance around all sides of the
appliance.
Ensure that the unit is used on a stable and level surface. If the oor surface is
uneven there is a risk that the appliance could tip over. Also, excessive vibration
and noise may occur. If the appliance should be accidentally tipped over, please
immediately disconnect from the power supply.
Do not use the appliance in wardrobes or near fabrics or clothing. Do not stand the
appliance on deep pile carpets.
Do not use the appliance in areas where petrol, paints or other ammable
substances are used or stored.
Do not use in very dusty areas as dust may accumulate on the heating elements
and cause overheating.
Do not use if there are any visible signs of damage to the appliance.
Do not operate the appliance in direct sunlight, near heat sources, humid
environments or in places near water or other liquids such as bathrooms, showers
or swimming pools.
Do not operate with wet hands or spill water or other liquids on to the appliance,
the mains cable or plug.
Always unplug the appliance when not in use.
Never leave the appliance unattended when in use.
CAUTION: Some parts can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
The heater must not be located immediately below a mains socket.
Do not allow children to play with the appliance or sit, stand, or climb on it.
Do not leave children alone or unattended in the area where the appliance is in
use.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied person in order to avoid a hazard.
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
Children of less than 3 years old should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/o the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children
aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance
Do not block or restrict the airow around the appliance. Position the unit so that
the air inlet and exhaust grilles are not blocked or restricted in anyway.
Do not push any objects in the air inlet and exhaust grilles.
Do not use the appliance with a programmer, timer or any other device that
switches the appliance on automatically. A re risk exists if the appliance is covered
or positioned incorrectly.
WARNING
In order to avoid overheating, do not cover the appliance.
IT IS HAZARDOUS FOR ANYONE OTHER THAN AUTHORISED SERVICE
PERSONNEL TO CARRY OUT SERVICING OF REPAIRS WHICH INVOLVE THE
REMOVAL OF COVERS.
TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT REPAIRS
YOURSELF.
DSG Retail Ltd. (co. no. 504877)
1 Portal Way, London, W3 6RS, UK
EU Representative
DSG Retail Ireland Ltd (259460)
3rd Floor Oce Suite, Omni Park SC
Santry, Dublin 9, Republic of Ireland
The symbol on the product or its packaging indicates that this product must not be disposed
of with your other household waste. Instead, it is your responsibility to dispose of your waste
equipment by handing it over to a designated collection point for the recycling of waste
electrical and electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help conserve natural resources and ensure that it is
recycled in a manner that protects human health and the environment.
For more information about where you can drop o your waste for recycling, please contact
your local authority, or where you purchased your product.
All trademarks are the property of their respective owners and all rights are acknowledged.
IB-L20TFH19-190705V2
Visit Partmaster.co.uk today for the easiest way to buy electrical spares and
accessories. With over 1 million spares and accessories available we can deliver
direct to your door the very next day. Visit www.partmaster.co.uk or call 0344 800
3456 (UK customers only). Calls charged at National Rate.
For general information about this appliance and handy hints and tips, please visit:
www.TeamKnowhow.com/discover or call 0344 561 1234
Thank you for purchasing your new product.
We recommend that you spend some time reading this instruction manual in order that
you fully understand all the operational features it oers.
Read all the safety instructions carefully before use and keep this instruction manual for
future reference.
Hot and Cool Fan Heater
Instruction Manual
L20TFH19
This product is only suitable for well-insulated spaces or occasional use.
L20TFH19_IB_Final190705V2.indd 1-3 08/07/2019 10:55
Product Overview
Control Panel
Unpacking
Remove all items from the packaging. Retain the packaging. If you dispose of it please do so
according to local regulations.
The following items are included:
Main Unit
Instruction Manual
Cleaning
Your heater should be cleaned regularly to prevent dirt and dust from building up which will
aect its performance. Ensure the air inlet and the air outlet are not blocked.
This can be done with a vacuum cleaner, using the brush attachment.
Hints & Tips
My heater does not work when I turn it on
Check that your heater is plugged in and the power is turned on at the mains socket.
Check that your heater is in an upright position.
If the heater still doesn’t work, do not try to repair the heater yourself.
If your heater’s power is automatically cut o follow the steps
below:
1. Unplug your heater and allow it to cool down.
2. Inspect your heater. Clean the air inlet and the air outlet with a vacuum cleaner if necessary.
If there is any sign of physical damage (e.g. melting, or burning of the case), do not attempt
to use your heater. Please leave all maintenance work to qualied personnel.
3. Plug-in the heater and switch it on again. If it cuts o again, move the heater to a better
ventilated location.
Specications
Model L20TFH19
Supply Voltage 220 - 240V~ 50Hz
Power Input Low: 1200 W; High: 2000 W
Features and specications are subject to change without prior notice.
If items are missing or damaged, please contact Partmaster (UK only).
Tel: 0344 800 3456 for assistance.
Ensure you unplug your heater from the mains socket and wait for the heater to
cool down completely before cleaning.
Do not use any detergents or abrasives and do not allow any water to enter the
heater.
Model L20TFH19
Item Symbol Value Unit Item Unit
Heat output Type of heat input, for electric
storage local heaters only (select
one)
Nominal heat
output
P
nom
2.0 kW Manual heat charge control
with integrated thermostat
no
Minimum
heat output
(indicative)
P
min
1.2 kW Manual heat charge control
with room and/or outdoor
temperature feedback
no
Maximum
continuous heat
output
P
max,c
2.0 kW Electronic heat charge control
with room and/or outdoor
temperature feedback
no
Auxiliary electricity consumption Fan assisted heat output no
At nominal heat
output
el
max
N/A kW Type of heat output/room
temperature control (select one)
At minimum heat
output
el
min
N/A kW Single stage heat output and
no room temperature control
no
In standby mode el
SB
N/A kW Two or more manual stages, no
room temperature control
no
With mechanic thermostat
room temperature control
no
With electronic room
temperature control
yes
Electronic room temperature
control plus day timer
no
Electronic room temperature
control plus week timer
no
Other control options (multiple
selections possible)
Room temperature control,
with presence detection
no
Room temperature control,
with open window detection
no
With distance control option no
With adaptive start control no
With working time limitation yes
With black bulb sensor no
Contact details DSG Retail Ltd. (co. no. 504877)
1 Portal Way, London, W3 6RS, UK
EU Representative
DSG Retail Ireland Ltd (259460)
3rd Floor Office Suite, Omni Park SC
Santry, Dublin 9, Republic of Ireland
Product Fiche
Operation
Position the heater upright on the oor away from curtains, furniture or wall coverings before
plugging your heater into the mains socket.
This unit will not operate unless positioned on a at stable surface or if the
thermostat is set too low.
General Operation
Once the unit is connected to the mains socket with power supply, the unit will prompt a
beep tone and the Power Indicator will light up.
Press the On/O Button to switch the unit on.
Press the Mode Button to switch between dierent modes.
When the unit is on, press the On/O Button to switch o the unit. The unit will prompt a
beep tone and the indicator of the selected mode will switch o.
Disconnect the mains plug from the mains socket to switch o the unit completely.
Carry Handle
Fan Cover
Control Panel
Mode Button
Power Indicator
High/Low Cool Fan
Indicator
On/O Button
Temperature Setting Button
Temperature Display
High/Low
Heat Level Indicator
Heater Operation
When the unit is on, press the Mode Button to switch the unit in Low Heat Level/High
Heat Level mode.
Press the Temperature Setting Button to select your desired temperature (18 / 21 / 24 / 27
/ 30).
It is normal for the heater to emit some smell and fumes when it is turned on for the
rst time or when turned on after not being used for a long period of time. This smell
will disappear when the heater has been turned on for a short while.
Auto Cool Down Function
Before the unit is completely switched o, it will take about 15 seconds in auto cool down mode
if it has been switched in Heater mode.
Fan Operation
When the unit is on, press the Mode Button to switch the unit in Low Cool Fan/High Cool Fan
mode.
Safety Protection
Overheat protection
When the temperature in the heater is too high due to abnormality in the use environment or
improper use, the thermostat device in the unit will automatically cut o the power to switch o
the unit. After the whole heater cools down, the heater will return to the normal use.
Turn over protection
When the unit is turned over, the safety system will automatically cut o the power. Make sure
that the unit is properly place upright and on a at surface.
L20TFH19_IB_Final190705V2.indd 4-6 08/07/2019 10:55
  • Page 1 1
  • Page 2 2

Logik L20TFH19 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI