2. Poewit
  3. WP-4
WP-4

Poewit WP-4 User guide

  • Hello! I am an AI chatbot trained to assist you with the Poewit WP-4 User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the maximum power consumption of the WP-4 Wall Pack?
    How many PoE pass-through ports does the WP-4 have?
    What is the maximum power budget for the PoE pass-through ports?
    What color temperatures are available for the WP-4 LED?
    How do I select the color temperature of the WP-4 LED?
    How do I install the WP-4 Wall Pack?
    How do I configure the WP-4 Wall Pack?
    Can I control the WP-4 Wall Pack without an internet connection?
poewit.com
CLOUD-INTELLIGENT
Powered by PoE + PoE Pass-Through
CCT | DIMMABLE
OUTDOOR
COMMERCIAL
WALL PACK
QUICK START GUIDE
WP-4
poewit.com
INSTALLATION AND SETUP
1
WARNING
THE WP-4 MUST BE POWERED WITH 802.3BT POE. THE WP-4
WALL PACK CONSUMES 40 WATTS OF POWER. IN ADDITION, IF
USING THE TWO POE PASS-THROUGH PORTS, THE TOTAL POE
BUDGET MUST BE SUFFICIENT TO POWER THE WP-4 AND THE TWO
DEVICES USING THE POE PASS-THROUGH PORTS. NOTE, EACH
POE PASS-THROUGH PORT CAN HANDLE UP TO 30 WATTS.
1) Getting to know your WP-4
a) Front Housing
b) Back Housing
c) PoE Driver with Two PoE Pass-Through Ports
d) Color Temperature Selection Switch
poewit.com
INSTALLATION AND SETUP
2
e) Wire Connector
poewit.com
INSTALLATION AND SETUP
3
2) Installation and Setup
a) Select the color temperature of the WP-4 LED (use table
below for reference).
Switch Position
Color Temperature OFF BRIDGE COOL WARM
3000k X X
5000k X X
4000k X NA
poewit.com
INSTALLATION AND SETUP
4
b) Separate the front and back housings by unscrewing the LED
connector wire and lifting the front housing off the hinges.
poewit.com
INSTALLATION AND SETUP
5
c) The back housing can be mounted to a wall or standard
electrical pancake box. Note, drill out only the necessary
holes to mount the back housing. It is highly recommend
to use silicon sealant on the drilled holes to prevent water
ingress over time.
poewit.com
INSTALLATION AND SETUP
6
d) Terminate and connect the CAT cables to the LED driver.
e) Before installing the front housing, ensure the rubber water tight
gasket is firmly seated.
poewit.com
INSTALLATION AND SETUP
7
f) Connect the LED driver connector and hang the front to the back
housing with the two screws (A hex tool is supplied / taped to
the housing).
poewit.com
INSTALLATION AND SETUP
8
3) Configuration Instructions
Power up device; you should be automatically connected to the
internet. You are now ready to download and install your app.
You can search PoEWit in the apple app store or Google Play to get
the app
Note: Your device and mobile phone both must have an internet
connection through the same external IP address and must be on
the same local subnet.
After initial conī¤guration, a PoEWit wall switch and/or PoEWit motion
detector PIR can control the lights should the internet connection go
down.
/