START THE APPLIANCE
Daily Use
1. Open the water tap and connect the mains plug to the mains
socket.
2. Press On/Off button to activate the appliance.
3. Put the laundry in the drum, one item at a time. Make sure that
no laundry stays between the seal and the door.
4. Close the door.
5. Put the detergent and additives in the correct compartment of
the dispenser.
6. Turn the programme knob to set a programme. The
programme indicator comes on.
7. The display shows the default temperature and maximum spin
speed. To change the default values or to set functions press
the corresponding buttons.
8. If necessary, set the delay start function. Press Delay Start
button repeatedly until the display shows the desired delay
time.
9. Press Start/Pause button to start the washing programme. If
you set the Delay Start, the appliance starts the countdown.
10. At the end of the programme the display shows a zero
, the
symbol of the last washing phase is on. The indicator of the
Start/Pause button and the door lock symbol go off. If you set
the Rinse Hold function refer to ‘At the end of the programme’
chapter in the user manual.
11. Unplug the appliance and close the water tap.
After Programme Start
Cancel the Delay Start
1. Press Start/Pause button.
2. Press Delay Start button until the display shows a zero.
3. Press Start/Pause button. The programme starts.
Interrupt a programme and/or change a function
1. Press Start/Pause button. Now you can change the function
set. The Time Save cannot be set in this case.
2. Press Start/Pause button. The programme continues.
Care and Cleaning
Clean the appliance
fi lter regularly.
Refer to “Care and
Cleaning” chapter
in the user manual.