Jaton Video-117PCI-16 User manual

Video-117PCI-16

Video-117PCI-32

multimedia accelerator

User Manual

version 1.00

2

NOTICE

The information in this document is subject to change in order to

improve reliability, design, or function without prior notice and does not

represent a commitment on the part of the company. In no event will the

company be liable for direct, indirect, special, incidental, or

consequential damages arising out of the use or the inability to use the

product or documentation, even if advised of the possibility of such

damages. No part of this manual may be reproduced or transmitted in

any form or by any means without the prior written permission of the

company.

June 2001, Rev. A

3

Contents

1. INTRODUCTION..........................................................................................5

2. FEATURES.....................................................................................................6

2.1 PCI BUS INTERFACE....................................................................................6

2.2 PERFORMANCE (@800 MHZ PIII WITH 32MB OF MEMORY)...............6

2.3 3D GRAPHICS ENGINE.................................................................................6

2.4 DVD SUPPORT.............................................................................................8

2.5 VIDEO ENGINE.............................................................................................8

2.6 ADVANCED POWER MANAGEMENT........................................................9

2.7 MEMORY BUS INTERFACE.........................................................................9

2.8 DIRECT 7.0....................................................................................................9

2.9 SOFTWARE...................................................................................................9

3. CHECK LIST...............................................................................................10

4. SYSTEM REQUIREMENTS......................................................................10

5. HARDWARE DESCRIPTION....................................................................11

5.1 BOARD LAYOUT AND SPECIFICATION..................................................11

6. HARDWARE INSTALLATION..................................................................11

6.1 INSTALLATION PROCEDURES.................................................................11

6.2 STEPS:.........................................................................................................12

7. SOFTWARE INSTALLATION..................................................................12

7.1 MICROSOFT WINDOWS®98 / ME...........................................................12

7.1.1 Microsoft Windows NT™4.0 .........................................................19

7.1.2 Microsoft Windows



2000............................................................24

7.1.3 Microsoft Windows® XP................................................................29

8. TECHNICAL ASSISTANCE (Q & A)......................................................33

8.1 TIPS..............................................................................................................36

9. VIDEO MODE REFERENCE TABLE........................................................36

9.1 STANDARD MODES...................................................................................37

9.2 EXTENDED MODES...................................................................................38

10. PINOUT AND SYNC FREQUENCIES...................................................41

10.1 ANALOG COLOR DISPLAY PINOUTS (DB 15)......................................41

4

10.2 CONVERSION TABLE: PIN ADAPTERS.................................................41

10.3 9-TO-15 PIN CONVERSION TABLE.........................................................42

10.4 ANALOG VIDEO SIGNALS.......................................................................42

11. FCC SHIELDED CABLE WARNING......................................................42

11.1 TECHNICAL SUPPORT ............................................................................43

12. LIMITED WARRANTY...........................................................................44

12.1 OTHER LIMITS.........................................................................................44

12.2 EXCLUSIVE OBLIGATION.......................................................................45

12.3 OTHER STATEMENTS............................................................................45

12.4 TERMS AND CONDITIONS......................................................................45

12.5 SERVICES AGREEMENT:..........................................................................46

12.6 ENTIRE OBLIGATION..............................................................................46

13. REDUCING WARRANTY CLAIM REJECTIONS................................46

5

1. Introduction

Video-117PCI-16 and Video-117PCI-32 are based on Trident Blade

T16/T64 (9970) Graphics Processor with PCI bus and DVD

playback. With 128-bit memory bus at 143 MHz clock on PCI bus

aggregation, the performance of these multimedia accelerators are

beneficial to brings the DVD playback in real-time and the high density

video formal expression at high pixel rate up to 286 million per

second, and that is biggest unparalleled cost/performance graphics

solution for today’s desktop application.

The most payoff on Trident Blade T16/T64 (9970) is that integrates

the advanced 2D/3D Graphics engine, which capable of supporting

with DVD, video, and digital TV into a single chip solution. The

overlying combines highly evolved per pixel 3D graphics engine setup

and rendering with 2D graphical user interface (GUI) acceleration can

blend the high speed low latency access on 128-bit totally. Taking

expediency of Direct Memory Access (DMA) to retrieve textures from

main memory, textures are no longer limited by local memory.

Trident Hardware Assisted MPEG-2 Architecture (THAMA™) enables

DVD playback support to the multimedia PC. Compared to software

only DVD players, the combination of software based decode and

hardware based motion compensation delivers smooth frame rates

without overloading the processor, requires no extra frame buffer and

minimum PCI Bus bandwidth.

For maximum throughput, the Video-117PCI-16 & Video-117PCI-32

are use PCI bus interface that supports at up to 1.06 GByte per second

transfer rate. Furthermore, Video-117PCI-16 & Video-117PCI-32 are

subsistence Microsoft graphics standard - DirectX 7.0 Cubic mapping,

and PC2001 compliant.

Jaton Corporation, USA.

6

2. Features

2.1 PCI Bus Interface

• PCI Bus Support at up to 1.06 GByte/sec transfer rate

• DMA bus mastering support with Scatter Gather

• Execute Mode for Direct Textures, Video, and DVD

2.2 Performance (@800 MHz PIII with 32MB of

memory)

• Pixel processing rate: 800 Million pixels/sec

• Texel access rate: 1,200 Million pixels/sec

• Supports 16MB/32MB of SDRAM at up to 143 MHz

memory clock

• 230 MHz RAMDAC for 1600x1200 resolution

• DVD playback in real-time (30fps) with 75% of CPU

headroom

2.3 3D Graphics Engine

2.3.1.1.1 Setup

− Up to 143 MHz clock

− Hardware interface to Direct 7.0

− 32-bit IEEE Floating Point Input Date

− 1/16 Sub-Pixel positioning accuracy for butter

image quality

2.3.1.1.2 Rendering

− Dual independent 64-bit pixel pipelines (128-bit

total)

7

− Single-pass processing of diffused, specular

lighting and fog

− Enhanced Gouraud Shading & Phong-like

environmental lighting

− Fast order-independent scene anti-aliasing

support

− Fully OpenGL-compliant blending including fog

& depth cueing

− Hidden surface removal with 16, 24, or 32-bit Z

buffer or W buffer

− Color format includes 16, 24, or 32-bit per pixel

− Supports 8-bit stencil buffer

2.3.1.1.3 Texturing

− Single-pass processing of up to 4 textures per

clock

− Single-pass Bi-linear, Tri-linear and Anisotropic

texture filtering

− Non-linear magnification and sharpening texture

filtering

− Multi-format texture cache

− Palletized texture format of 1, 2, 4, and 8-bit per

pixel

− Non-palletized texture of 16 or 32-bit per pixel

− Pallete data format with 565, 1555 or 4444 for

ARGB

− Texture color keying & enhanced filtering for

translucent objects

2.3.1.1.4 2D GUI

− 128-bit graphics engine

− 8/15/16/24/32-bit per pixel color formats

8

− 256 Raster Operations (ROPs)

− Hardware support for all 2D functions (BitBLT,

lines, polygons, fills, patterns, clipping, bit

masking…)

− Panning, scrolling, clipping, color expansion,

sprites

− Built-in 32x32 and 64x64 Hardware Cursor

2.4 DVD Support

• THAMA™ architecture enables full DVD player support

• Requires no extra frame buffer and minimum PCI bus

bandwidth

• Includes both Motion Compensation and IDCT hardware

assist

• Real-time playback (30fps) of 9.8 Mbps MPEG-2 video

bitstream with 80% CPU headroom for other application

• Alpha blending for subpicture

• Advanced error recovery & concealment

• Programmable multi-tap filtering

• Pan and scan support

• Anti-tearing support

• Supports DVD version 1.0 and VCD version 2.0

2.5 Video Engine

• State-of-art video de-interlacing

• Capable of supporting HD0 HDTV resolution (1280x720)

• TrueVideo® bilinear interpolation with proprietary edge

recovery scaling

• Dual apertures for simultaneous access to graphics and

video display memory area

9

• Dual color space converters (CSC)

• Accelerates YUV planar format

2.6 Advanced Power Management

• 7 GPIOs, suspend and standby modes

• Internal clock gating on each functional block

• PCIPM (H/W PCI initiated)

• AGP Clock Busy/Stop and PCI Clock Run

• ACPI and DPMS support

2.7 Memory Bus Interface

• 64-bit SDRAM/SGRAM memory bus at 143 MHz clock

• Up to 32 Mbytes of local frame buffer

2.8 Direct 7.0

• Microsoft graphics standard for Windows 2000

• hardware support of Cubic mapping reflections, refraction

and lighting

• Hardware support of environment and emboss bump

mapping

• Hardware support of texture compression

• Hardware support of all data formats for setup processing

• Adaptive sharing of Transform & Lighting processing

with CPU

2.9 Software

• Window 98/Me and Window 2000/XP

• Windows NT 4.0

• DirectX 6.0, 7.0

• DirectShow 3.0 and 4.0

10

• OpenGL ICD 1.0 and 1.2

3. Check List

The package you have purchased should contain the following:

þ Video-117PCI-16, or Video-117PCI-32 multimedia

accelerator

þ Software and Document CD

þ Quick Start Guide (Printed)

If any of these items is missing or damaged, contact your dealer.

IMPORTANT: Keep all packaging materials that accompany your

adapter in the event you need to return the product.

4. System Requirements

• Intel or compatible Pentium® II system with PCI Bus

Extension Slot

• CD-ROM drive, Quad speed or faster

• Hard Drive with at least 10MB Free space

• MS Windows®98/Me, Windows® NT4.0, Windows2000/XP

operating systems

11

5. Hardware Description

5.1 Board Layout and Specification

Display memory

PCI BUS

Y

1

Plate

S_Video

Composite Video

DB 15 VGA

Product's Name / PCB version Core Chipset / PCB size Memory Module / Size

Video-117PCI-16

Video-117PCI-32

82117K

Trident Blade T16

Trident Blade T64

W = 5.6" x H = 3.1"

W = 5.6" X H = 3.1"

2M X 16 SDRAM X 4

4M X 16 SDRAM X 4

16MB

32MB

WIDTH

HEIGHT

Y

2

TVout optional

Trident

Blade-Txx

6. Hardware installation

6.1 Installation Procedures

!! WARNING !!

Discharge static electricity by

touching the GROUND such as

metal part of your case connected

with good power ground before

you handle the electronic circuit

boards.

The manufacturer assumes no liability for any damage, caused

directly or indirectly, by improper installation of any components by

unauthorized service personnel. If you do not feel comfortable

performing the installation, consult with a qualified computer

technician.

12

6.2 Steps:

1. Turn OFF all powers to your system, including any

peripherals (printer, external drives, modem, etc.).

2. Disconnect the power cord and the monitor cable from the

back of the computer.

3. Unfasten the cover mounting screws on your system and

remove the system cover. Refer to your system user manual

for instructions to determine the location of the mounting

screws.

4. Remove any graphics adapter that already installed on your

motherboard. Start by removing the screw that holds the

adapter retaining bracket in place (keep this screw, you will

need it later). Then, gently pull straight up on the adapter card

itself, and remove it from the motherboard.

5. Refer to your computer system manual for the location of the

PCI bus expansion slots. Remove the retaining screw that

holds the slot cover in place. Slide the slot cover out and put

the screw aside (you will need it to secure the adapter).

If you just removed an existing graphics adapter and are not

going to use that expansion slot, you can install the slot cover

you just removed from the unused expansion slot to cover the

open hole.

6. To install the adapter in the selected expansion slot, carefully

line up the gold-fingered edge connector on the adapter

directly above the expansion slot connector on the

motherboard. Then press the adapter into place, completely,

with necessary but minimum pressure. DO NOT USE

excessive force. Use the (remaining) screw you removed to

secure the adapter retaining bracket in place.

7. Replace the computer cover. Secure the cover with the

mounting screws you removed in Step 3.

You have now completed the installation of your new graphics adapter

on your system.

7. Software Installation

7.1 ÿÿ Microsoft Windows®98 / Me

Start Windows with VGA or SVGA drive detected. Insert the software’s CD

into your CD-ROM drive (e.g. X:). Typically, D: or E: drive, etc.

13

1. Autorun feature pops-up “Welcome” screen from software’s CD, click on

the "Display Driver" selectable text to start installation.

14

2. Tab to “Settings” screen, then click on “ Advance” button.

15

3. Click on “Next” button with [Advanced] selectable option.

16

4. You may proceed the search wizard with “Display a list of all the driver in

a specific location, so you can select the driver you want.” option, then

click on “Next” button.

5. Click on “Have Disk…” button to continue.

17

6. You may type E:\V-117\Win9x into the dialog box as shown above, or

browse on CD, unfold these folders; and click on “OK”. (If E is not your

CD-ROM drive , substitute E with the correct drive letter.)

7. Wizard has selected “Video-117PCI (Trident Blade T16/T64)” then

press on “OK” button.

18

8. Windows is ready to install the driver for your hardware from CD-ROM

drive, please click on “Next” to do so.

9. Windows system transmit all files to your local hard disk drive, please wait

until the process is over.

19

10. Click on “Finish” to complete the driver installation.

7.1.1 ÿÿ MICROSOFT WINDOWS NT™4.0

Windows NT dose not identify the new PCI video adapter, and

always placed a default VGA video setting when system boots up.

To maximum the video board acceleration and performance, you

should install the video driver that is provide from video adapter

manufacturer. Please insert the software CD into your CD-ROM

drive after your desktop fully loaded with default video settings.

20

1. Autorun feature brings-up “Welcome” screen, CLICK on “Display Driver”

selectable text to start the installation.

Page is loading ...

Jaton Video-117PCI-16 User manual

This manual is also suitable for

Jaton Video-117PCI-16 User manual

Related papers

Other documents