Anova E20TPA Installation guide

Hello! I've reviewed the Installation Instructions for the Element Surface Mount receptacles from ANOVA. This document provides detailed steps for installing these receptacles on both concrete and wood floors, including necessary tools and hardware. I'm ready to answer any questions you may have regarding the installation process or the features of the receptacles described in this guide.
What type of footing or slab is required for installation?

What tools are needed for installation?

What hardware is needed for installation?

What should i do if the holes in the concrete are too large?

Hammer Drill

Masonry Drill Bit Set

1/4" & 16/64"

Hammer

7/16 "Wrench

Safety Glasses

anovafurnishings.com

888.535.5005 tel

TOOLS NEEDED: HARDWARE NEEDED:

Installation Instructions

All Element Receptacles Surface Mount

Step-by-Step Installation Sequence

Product ships fully assembled.

Examine the footing or slab for damage or defects. The footing or slab should be reinforced concrete rated at a

3,000 psi minimum and be cured for at least 28 days prior to the installation of the receptacle.

CAUTION: Oversized holes and holes drilled too deep in the concrete will make it dicult to set the anchor.

Drill

A. (2) 3/4” x 1-5/16” x 2-1/4” Brackets

B. (2) 1/4” x 1-1/2” Lag Screws

C. (2) 1/4” x 1-1/2” Masonry Anchors

D. (2) 1/4-20 x 3/4” Self Threading Screws

PANELHLD hold down Kit

Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.

Installation Instructions

Step-by-Step Installation Sequence

1. Position the receptacle and the bracket (A) on the oor with the short side

of the bracket at on the oor and the long side against the corner of the

frame.

Insert a 1/4-20 x 3/4” screw (D) through the bracket and into the hole in the

bottom frame and tighten in place.

Install the remaining bracket on the opposite corner of the receptacle in the

same manner.

To install on wood oors, use your drill and 13/64” drill bit to drill a hole 1-3/4”

deep through the horizontal hole in the bracket and into the oor. Then insert

a lag screw (B) through the bracket into the hole in the oor and tighten in

place. Repeat this step for the opposite corner.

To install on concrete, use your rotary hammer drill and a 1/4” masonry drill

bit to drill a hole 1-3/4” deep in the concrete through the horizontal hole in

the bracket. Then insert a masonry nail anchor (C) through the bracket and

into the hole in the concrete and hammer the pin until ush with the top of

the bracket. Repeat this step for the opposite corner.

2. Using your drill and 13/64” drill bit, drill through the vertical hole in the

bracket and through the bottom frame of the receptacle.

All Element Receptacles Surface Mount