Philips DS8530/93 Owner's manual

Introduction:

Philips strives to continually bring you the best experience from our products. To obtain the optimal

playback and latest features, you are highly recommended to update the firmware of your player.

Preparation for firmware update:

For update via your Apple products:

 Download and install Philips Fidelio APP via iTune to your iPod/iPhone/iPad supported

by your Philips docking player.

 Recommend to connect your Apple products via Wi-Fi.

Update Procedure:

Step 1: Check your current firmware version (Not require to run Fidelio APP)

1. Power on your Philips docking player.

2. Dock your Apple product onto it.

3. In your Apple product menu, select [Settings] > [General] > [About] > [Docking Speaker].

4. The firmware version will be displayed on the screen.

Step 2: Upgrade the firmware for your player

Note: It is recommended to activate Wi-Fi network on your iPhone/iPad to upgrade, otherwise the

streaming data will be counted by your mobile service provider.

1. Power on your Philips docking player.

2. Dock the Apple product onto the player.

3. Run Philips Fidelio APP .

4. If there is newer firmware ready, pop-up prompt will be displayed in the app to ask for

upgrade or select the [Firmware Update] in the Fidelio APP setting page.

5. Choose “Yes” to proceed upgrade.

6. After upgrade, the Philips play will reboot.

7. The APP will report that the upgrade is successful.

Step 3: Confirm upgrade successfulness

1. Go over Step 1 Check your current firmware version to verify if the new firmware is

correctly upgraded.

2. If the latest firmware has not been installed, repeat ‘Step 2 Upgrade the firmware for your

player’ and ‘Step 3 Confirm upgrade successfulness’.

1. Check your current firmware

version

2. Upgrade the firmware for your

player (via either internet network

or a USB flash drive)

3. Confirm upgrade

successfulness