2. Computers & electronics
  3. Networking
  4. Cable network testers
  5. Schneider Electric
  6. Resi9 RCCB - R9R*****

Schneider Electric Resi9 RCCB - R9R***** Instruction Sheet

  • I have reviewed the instruction sheet for the Schneider Electric Resi9 R9Rppppp Residual current circuit breaker. This document provides important safety and installation information for the device, including the proper testing and maintenance procedures. The document emphasizes the need for a qualified electrician to handle the device, and that regular testing of the device is important to protect the electrical system. I am ready to answer your questions about this device.
  • Who should install this device?
    Can this device be repaired?
    What should I do if the device is damaged upon unpacking?
    How often should I test the device?
06/2023 1/2
GEX2685400-00
Instruction sheet
Resi9 RCCB - R9Rppppp
TM
Residual current circuit breaker
(RCCB)
Compliant with AS/NZS 61008.1
2Installation
Load terminals
Top Feeding
O OFF O OFF
Load terminals
Bottom Feeding
1Description
N
RCBO
RCBO
O OFF
AB
N
N
C
D
AClip for DIN rail mounting
BConnection terminals
CTest button
DVISI-SAFE: Positive contact indication
Resi9
GEX26854
Resi9Resi9
PLEASE NOTE
b The installation, maintenance and eventual replacement of this device must only be carried
out by a qualified electrician.
b This device must not be repaired.
b All applicable local, regional and national regulations must be complied with during the
installation, use, maintenance and replacement of this device.
b This device should not be installed if, when unpacking it, you observe that it is damaged.
b Schneider Electric cannot be held responsible in the event of noncompliance with the
instructions in this document and in the documents to which it refers.
b The service instruction must be observed throughout the life time of this device.
b
b
b
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
Turn off all power supplying this product before working on it.
Use a voltage tester with a suitable rated voltage in order to check
that all active conductors aren’t energized.
Carefully inspect the work area to check that no tools or objects could
have been left inside the equipment.
Failure to follow these instructions will result in death or serious injury.
DANGER
14 mm
1...35 mm²
1...25 mm²
C
3.5 N.m
6.5 mm
PZ2
© 2023 Schneider Electric - All rights reserved.
Schneider Electric Industries SAS
35, rue Joseph Monier
CS 30323
F - 92506 Rueil Malmaison Cedex
www.se.com
GEX2685400-00 2/2
3Regular test
I ON
I ON
Clack!
O OFF
O OFF
4More information
R9R
ppppp
Resi9Resi9
Resi9
Resi9
Note: Test the device at regular intervals by pressing the Test button (marked T), following the intervals defined in your local regulations or monthly.
/