Page is loading ...
The unique design of the patented Frick®
SuperCoalescer™ with EZ-Drain feature and
self-centering notch provides:
• 20% increase in velocity limit
- Fewer oversized oil separators
- Improved system performance
• Reduced pressure drop across the coalescer
element
- Increased compressor efciency with re-
duction in horsepower
Installing the coalescing element
1. Orientate the 531B0099H_ Coalescing Ele-
ment with the DRAIN DOWN tag on the
bottom, at the 6 ’clock position.
Johnson Controls
100 CV Avenue
Waynesboro, PA 17268
Phone: 717-762-2121 • FAX: 717-762-8624
www.johnsoncontrols.com/frick
Form 160.100-IB (2021-11)
Supersedes: 160.100-IB (2021-09)
Subject to change without notice
Published in USA • 11/21 PDF
© 2021 Johnson Controls - All Rights Reserved
NOTICE
These elements are only for horizontal applications
.
Original equipment
For Genuine Frick® Replacement Parts, contact:
Johnson Controls Inc.,
Frick Parts Center,
9104-D Yellow Brick Road,
Baltimore MD 21237
Email: [email protected]
Phone: (800) 336-7264
CAUTION
Incorrect drain position decreases performance.
Form 160.100-IB (NOV 2021)
Installation Bulletin
File: Service Manual - Section 070
Replaces: 160.100-IB (SEP 2021)
Dist: 3, 3a, 3b, 3c
Part No: 531B0099H21, 531B0099H22,
531B0099H23, 531B0099H24
(Patent 7686859)
Description: High-efciency, high-performance
coalescer element
2. The required mounting torque is 21 ft⋅lb.
Excessive torque may damage the element
and result in oil carryover.
Figure 1: Coalescing element
Notes:
• The part number, torque value, and date code are shown on the side of coalescer
• The bridge is recessed on certain models, and image may not reect actual bridge location.
/
