ZUEXT 3216564266 User guide

Type
User guide

This manual is also suitable for

1
How to do UTP cable test for
ZUEXT in-1 CCTV Tester
Step 1: Pls kindly read the User Manual first, and find below cable in the package
box to connect network;
Step 2: Pls connect the CCTV tester, and check below 3 photos.
2
Step 3: Pls kindly note the third photo which shows 1V 2V 3V...8V.
V means newtork cable is connected well. If the screen shows 1X 2X
3X...8X, then it means the network is disconnected. From the above three
photos, we can find that there is no problem for your network cable
which means the UTP testing is successful. "No signal " means you have
not yet connected the cameras, and it does not mean there is problem
with the UTP function.
  • Page 1 1
  • Page 2 2

ZUEXT 3216564266 User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI