Legrand Cable Modem Mounting Plate, IS-0073 Installation guide

Brand: Legrand

Model: Cable Modem Mounting Plate, IS-0073

Type: Installation guide

IS-0073 Rev. O Page 1 of 2

OnQOnQ

OnQ Technologies, Inc.

P.O. Box 60907

Harrisburg, PA 17106

Phone: 800-321-2343

Instruction/Installation Sheet

OnQ Cable Modem Mounting Kit

IS-0073

Rev. O

Figure 1

Packaged Part Number:

364254-01 Cable Modem Mounting Kit (Figure 1)

Kit includes: 1 - Panel with Cable Splitter 1 – Velcro Strap

1 - F-F Cable (15in)

1. Introduction:

The OnQ Cable Modem Mounting Kit is designed for use with the Bay Networks Cable Modem (as well as other

cable modems). The Mounting Kit is for installation into the OnQ Tri-rail or Flat-rail Service Center Enclosures.

2. Description:

The OnQ Cable Modem Mounting Kit, when assembled, connects between the incoming cable service and the

video module for video service, telecom module wide area network inputs, telecom network interface, or directly

to the hub for 10BASE-T information service. It provides a 10BASE-T interface to the delivered Information

Services/Internet.

3. Installation

A. Assembly – Refer to Figure 2.

1) Place Modem on mounting plate. Secure modem using the velcro strap.

2) Connect F-F (supplied), cable from output of cable splitter to the modem input “F” fitting.

Figure 2.

IS-0073 Rev. O Page 2 of 2

B. Mounting in enclosure – Refer to Figure 3.

1) Align tabs on assembly with slots on rail of enclosure.

2) Insert tabs by angling assembly away from the back of the enclosure and sliding forward.

3) Rotate the assembly and insert fasteners on assembly into corresponding holes on rail of

enclosure. (Plunger must be in the pulled out position for fastener to engage hole.)

4) Push plunger in to lock module in place. Pull on assembly to assure assembly is locked

properly in place.

Figure 3.

Service Connection – See Figure 4.

1) Identify incoming service cable and route to “Cable In” fitting on splitter. In routing cable,

allow slack for bundling cables to the side. Trim cable to allow loose loop of cable to the

connection.

2) Connect an RG6 Jumper Cable to “Cable Out” on splitter. Route cable to “Cable In” input of

video distribution module.

3) Route a CAT 5 jumper cable to the “Wide Area Network” or the “Data” input of a telecom

module, a network interface, or directly to a 10BASE-T hub.

4) Plug modem power supply into a 120 VAC source.

Figure 4.

Legrand Cable Modem Mounting Plate, IS-0073 Installation guide

Legrand Cable Modem Mounting Plate, IS-0073 Installation guide

Legrand Cable Modem Mounting Plate, IS-0073 Installation guide

Related papers

Other documents