IVIEW 1070TPC Operating instructions

Brand: IVIEW

Model: 1070TPC

Type: Operating instructions

Android Installation

Preparation

You will need the following:

- A USB Cable

- PhoenixSuit (which can be found HERE)

- Your devices’ firmware (which can be found HERE)

- A PC that is Windows 7 or higher

- A .RAR file extracting program (7-zip, etc.)

- GMS Override firmware (which can be found HERE)

1.) Download and install PhoenixSuit

2.) Download and extract both the GMS Override firmware and your device’s firmware. (NOTE: File

name will be different than the example below)

3.) Run PhoenixSuit

4.) Select the Firmware tab (the Anchor icon) highlighted in RED.

5.) Select the “Image” button (highlighted in RED).

6.) Select the GMS Override firmware and select Open.

7.) Firmware will be loaded

8.) With the firmware loaded, make sure your tablet is completely powered off.

9.) Press and hold down the V+ Button (If your device has no volume buttons, you can use the

Return Button) and use your USB Cable to connect your tablet to your PC

10.) Once you’ve connected your tablet to your PC, press the power button rapidly, while still

holding the Vol+ or Button.

11.) If done correctly, you will be prompted twice. Selected “Yes” both times.

12.) Firmware installation will begin. It will take a few moments.

13.) Message will pop up, saying that installation is complete. Click “OK”.

14.) After installing the GMS Override firmware, repeat Steps 3-13 for your device’s firmware. After

you finish Step 13 for your device’s firmware, disconnect the tablet.

15.) The tablet is ready for use.

1
2
3
4
5

IVIEW 1070TPC Operating instructions

Brand: IVIEW

Model: 1070TPC

Type: Operating instructions

Related papers

Other documents