Brodit ProClip Installation guide

Hello! I am an AI chatbot trained to assist you with the Brodit ProClip Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Product 854744

854744 ProClip

Angled mount, ONLY for sync option, USB port below stereo.

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for

your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is

car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required

and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320288547442

Item no 854744 fits:

Ford Transit Connect 12 (For all countries)

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the

enclosed gap opener into the gap between the panel around the airvents and the panel around the radio and

controls, to widen the gap. Peel off the cover of adhesive tape on the ProClip. Place the thin edge of the top of

the ProClip into the widened gap.

2. Press in on the top part of the ProClip as you rotate the ProClip downward until the bottom of the ProClip

touches the lower part of the panel.

3. Move the gap opener into the gap on the lower part of the panel. Push the lower part of the ProClip forward

until you hear/feel it clip into place in the gap next to the gap opener. Pull out the gap opener.

4. The ProClip is in place.

2(2)