Brodit 804700 Datasheet

Category
Car kits
Type
Datasheet
3 February, 2012, www.brodit.com, © 2012 Brodit AB
Product 804700
804700 ProClip
Left mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288047003
Item no 804700 fits:
Nissan Tiida 12 (For all countries)
Nissan Tiida Latio 12 (For Europe)
Nissan Versa Sedan 12 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of
adhesive tape on the ProClip. Pull/flip the rubber sealant open on the A-Post. Note: Use the enclosed gap opener
to flip the sealant open if it is tight. Insert the angled edge on the lower part of the ProClip into the gap and hook it
behind the A-post panel edge.
2. Press firmly upwards with your left hand on the bottom part of the ProClip and toward the left on the side of the
ProClip with your other hand. Press until you see, hear or feel the angled edge on the upper part of the ProClip
hook around the A-post panel edge by the windshield.
3. Press down on top of the ProClip to make sure the angled edge is all the way into the gap. Note: If the gap is
tight between the windshield and the A-post panel, use the enclosed gap opener to widen the gap.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 804700 Datasheet

Category
Car kits
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI