Brodit 834703 Datasheet

Category
Car kits
Type
Datasheet
28 February, 2012, www.brodit.com, © 2012 Brodit AB
Product 834703
834703 ProClip
Console mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288347035
Item no 834703 fits:
Land Rover Range Rover Evoque 12 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the
enclosed gap opener into the gap between the center console panel frame and the console edge, to widen the
gap. Peel off the cover of adhesive tape on the ProClip. Press the angled edge on the left side of the ProClip into
the gap next to the gap opener. Pull out the gap opener.
2. Push firmly on the right side of the ProClip so it flexes downward and hooks around the console sidewall edge.
Press forward on the lower side of the ProClip to make sure the angled edge is hooked all way around the
console edge.
3. This ProClip fits on the right and left side of the center floor console. You can also use one on each side.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 834703 Datasheet

Category
Car kits
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI