Brodit 834708 Datasheet

Category
Car kits
Type
Datasheet
12 January, 2012, www.brodit.com, © 2012 Brodit AB
Product 834708
834708 ProClip
Console mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288347080
Item no 834708 fits:
Nissan Juke 11-12 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Press the thin end of the enclosed gap opener into the gap/seem between the console edge and the panel
surrounding the gear shift, to widen the gap. Use the enclosed alcohol pad to clean the area where the ProClip is
to be installed. Peel off the cover of adhesive tape on the ProClip.
2. Press the angled edge on the left side of the ProClip into the gap next to the gap opener. Pull out the gap
opener.
3. Press down on the top right side of the ProClip so it flexes downward and the angled edge hooks around the
panel edge in the console sidewall.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 834708 Datasheet

Category
Car kits
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI