2. Hubbell Premise Wiring
  3. HWS775463

Hubbell Premise Wiring HWS775463 Installation guide

  • Hello! I've reviewed the provided instruction sheet for the Hubbell HWS77546301 deep vertical organizer. This document details how to mount the organizer to a relay rack, how to open and close the doors, and which parts are included. I'm ready to answer any questions you have about the installation or use of the device.
  • What is included with the wire organizer?
    How do I mount the organizer to a relay rack?
    How do I operate the doors?
Hubbell Premise Wiring, HUBBELL INCORPORATED (Delaware)
23 Clara Dr., Mystic, CT 06355 (800) 626-0005, Fax (860) 535-8328
www.hubbell-premise.com
Control No. Page of
Rev. Date: Hubbell Premise Wiring Instruction Sheet
®Control No. Page of
Rev. Date:
HwS77546301 1 4
1 12/13/17
HwS77546301 4 4
1 12/13/17
dEEP VERTICAL ORGANIZER
1) Place Cable Organizer (Item 1) next
to Relay Rack (sold separately).
2) Align the holes on the side of the
organizer with the holes on the rack.
3) Secure in place using 1/2" bolt, nut,
and lock washer (Items 5,3,4 in
Figure 2).
ITEM DESCRIPTION QTY.
1 WIRE ORGANIZER 1
2 DOOR 2
3 1/3-13 X 1" HEX HEAD BOLT 4
4 1/2-13 HEX HEAD NUT 8
51/2" LOCK WASHER 4
6 1/3-13 X 1.25" HEX HEAD BOLT 4
71/2" FLAT WASHER 4
4
35
2
1
7
3
2
FIGURE 1
FIGURE 2
1MOUNTING ORGANIZER TO RELAY RACK
FIGURE 4
OPTIONAL
The 3/4" Diameter holes allow the organizer to be
secured to the oor.
(Hardware not included)
Control No. Page of
Rev. Date:
Control No. Page of
Rev. Date:
HWS77546301 2 4
1 12/13/17
HwS77546301 3 4
1 12/13/17
1
3
3
45
45
2
FIGURE 2A FIGURE 2B
3OPERATING THE DOORS
ATTACHING THE DOOR.
With both door handles in the "up" position, align the 4 clips, that are on the
door (top and middle), with the rungs on the organizer as shown (Fig. 2A)
and press.
With the door handles still in the "up" position, slide the 4 black plastic hinge
cones that are attached to the door (1 pair is just below the 2 top clips and
the other pair is near the bottom of the door), onto rungs while sliding the
door handles down. (Fig. 2B).
TO OPEN: Lift up on either handle and swing out.
FIGURE 3B
FIGURE 3A
TO CLOSE: Lift up on either handle and swing close,
then release handle into "down" position.
UP
U
P
Both handles in
"UP" position
Both handles
in "DOWN"
position
Hinge cone on
rung, shown with
door handles in
"DOWN" position
/