ADTRAN 1442703PG2 Datasheet

Brand: ADTRAN

Model: 1442703PG2

Category: Network transceiver modules

Type: Datasheet

ADTRAN 1442703PG2 is a Small Form-Factor Pluggable (SFP) transceiver that provides an OC-12 CWDM interface to the supporting system. It is compatible with SONET OC-12 (622.08 Mb/s) 1491 nm, long reach, single-mode, 2-fiber operation and has a maximum optical span of 80 km.

jobAid

DESCRIPTION

TheOC‐12SmallForm‐FactorPluggableCWDM1491nm(SFP

OC‐12)plugsintoADTRANOC‐12equipmentdesignedtoaccept

SmallForm‐factorPluggables(SFPs).

Installedintoanappropriatehostunit,theSFPOC‐12providesan

OC‐12CWDMinterfacetothesupportingsystem.

NOTE

Toensurecompatibility,refertothedocumentationprovided

withthehostmodule.

ThefollowingfeaturesaresupportedontheSFPOC‐12:

♦ SONETOC‐12compatible(622.08Mb/s)1491nm,

longreach,single‐mode,2‐fiberoperation

♦ 80kmmaximumopticalspan

CAUTION

Duetocompliancecertificationrequirements,useonly SFPs

suppliedbyADTRANwiththehostmodule.ADTRANcannot

certifysystemintegritywithotherSFPs.

SPECIFICATIONS

♦ OpticalSpecifications:

◊ Opticaltransmitlevel:–3dBmto+5dBm

◊ Opticalreceivelevel:–28dBmto–8dBm

◊ Powerpenalty:–1dB

◊ Opticalbudget:24(±1)dBm

◊ Minimumspanattenuation:13dB

◊ Opticalconnectors:LC

♦ ExtendedEnvironmentalSupport:

◊ Operationaltemperaturerange:–40°Cto+65°C

◊ Storagetemperaturerange:–40°Cto+85°C

◊ Relativehumidityto95%,noncondensing

OC-12 Small Form-Factor Pluggable

CWDM 1491 nm

INSTALLATION

ToinstalltheSFPOC‐12intoanappropriatemodule,complete

thefollowingsteps:

1. InspecttheSFPOC‐12.Ifdamaged,fileaclaimwiththecar‐

rierandthencontactADTRANCustomerSupport.

CAUTION

DonotremovetheprotectiveendcapfromtheSFPuntilthefiber

opticcableisreadytobeconnected.

2. InserttheSFPOC‐12intotheSFPcageonthemodule.

Ensurethatthemanufacturer’slabelontheSFPisfacing

upwardforcorrectinstallation.

3. SlidetheSFPOC‐12allthewayintothereceptacleuntil

thereisanaudible“click”.

NOTE

ThelatchontheSFPisusedtoremovetheSFPfromthecageon

thecircuitcard.

PROVISIONING

The SFPOC‐12 is not directly provisionable. To provision the

SFPOC‐12, access the menu system of the host module.

Refer to the “Provisioning” section of the Job Aid or I&M

provided with the host module for provisioning details.

SAFETY AND REGULATORY COMPLIANCE

CAUTION

ElectrostaticDisc harge (ESD)candamageelectronicmodules.

Whenhandlingmodules,wearanantistaticdischargewriststrap

topreventdamagetoelectroniccom pon ents .Placemodulesin

antistaticpackingmaterialwhentransportingorstoring.When

wor kin g on modules, always placethem on an approved

antistaticmatthatiselectricallygrounded.

TheSFPOC‐12isNRTLListedtotheapplicableULstandards.

TheSFPOC‐12meetsorexceedsalltheapplicablerequirements

ofNEBS,TelcordiaGR‐63‐CORE,GR‐1089‐CORE,andETSIEN

300368.

TheSFPOC‐12isintendedfordeploymentin

CentralOfficetype

facilities,EEEs,EECs,andlocationswheretheNECapplies(for

example,CustomerPremises).TheSFPOC‐12istobeinstalledin

ADTRANproductsinRestrictedAccessLocationsonly,and

installedbytrainedservicepersonnel.

CLEI: SOOTAKNJ_ _

Product P/N: 1442703PG2

Issue Date: December 2010

Document P/N: 61442703PG2-22B

C A U T I O N

SUBJECT TO ELECTROSTATIC DAMAGE

OR DECREASE IN RELIABILITY.

HANDLING PRECAUTIONS REQUIRED.

Warranty: ADTRAN will replace or repair this product within the warranty period if it does not

meet its published specifications or fails while in service. Warranty information can

be found online at www.adtran.com/warranty

ADTRAN CUSTOMER CARE:

From within the U.S. 1.800.726.8663

From outside the U.S. +1 256.963.8716

PRICING AND AVAILABILITY 1.800.827.0807

*61442703PG2-22B*

ThisdevicecomplieswithPart15oftheFCCrules.Operationis

subjecttothefollowingtwoconditions:

1. Thisdevicemaynotcauseharmfulinterference.

2. Thisdevicemustacceptanyinterferencereceived,including

interferencethatmaycauseundesiredoperation.

ChangesormodificationsnotexpresslyapprovedbyADTRAN

couldvoidtheuserʹs

authoritytooperatethisequipment.

CAUTION

TheSFPOC‐12containsaClass1laserthatcomplieswiththe

LaserSafetyrequirementsofFDA21CFR1040.10and 1040.11,

andEN60825‐1,and‐2.TheSFPOC‐12isNRTLListedandCB

Certifiedto all applicable American andEuropean safety

standards.

CAUTION

♦ PerGR‐1089‐CORESection9,theSFPOC‐12 does not have

an internal DC connection between battery return and

frame ground.

♦ The ADTRANsystemthattheSFPOC‐12isbeingdeployedin

isdesignedandintendedforinstallationaspartofaCommon

BondingNetwork(CBN),orIsolatedBondingnetw ork(IBN).

♦ The SFPOC‐12canbeinstalledinaDC‐I(isolated)orDC‐C

(common)configuration.Forinstallationswhereothercards

orthehostsystemha veinternalconnectionsbetweenbattery

returnandframeground,thesystemwould beintendedfor

deploymentonlyinaDC‐Cconfiguration.

♦ TheADTRANsystemchassisframegroundterminalmustbe

connectedtoareliableearthgroundtoens urethatthemetal

enclosureoftheSFPOC‐12isproperly groundedviathe

backplaneconnector.

NOTE

♦ TheOC‐12port(s)areopticalandthereforearenotclassifiedas

anytypeofportasdefinedinAppendixBofGR‐108 9‐CORE

Issue5.

♦ This SFP OC‐ 12 is compliant with SFF‐ 8472 “Digital

DiagnosticsMonitoringInterfaceforOptica lTransceivers,”

Revision9.3.

♦ ThisSFPOC‐12iscompliantwiththeSmall Form‐Fa ctor

Pluggable(SFP)Multi‐SourceAgreement(MSA).

♦ Thisproductisdesig nedtobedeployedinGR‐3108‐CORE

environmentclass1or2asdefinedinGR‐3108‐COREissue2.

TheSFPOC‐12isdesignedtomeetthefollowingenvironmental

classes:

♦ ETSIEN300019‐1‐1“Classificationofenvironmental

conditions;Storage,”Class1.2

♦ ETSIEN300019‐1‐2“Classificationofenvironmental

conditions;Transportation,”Class2.3

♦ ETSIEN300019‐1‐3“Classificationofenvironmental

conditions;Stationaryuseatweather‐protectedlocations,”

Class3.3

Thisproducthasbeenevlauatedtointernationalsafetystandards

EN60950‐1,AS/NZS60950.1,andIEC60950‐1.Thisproduct

meetstherequirementsforCEmarkingundertheEMCDirective

andLowVoltage

Directive.Standardsusedtodemonstrate

ComplianceareEN300386andEN60950.

Theequipmentisdesignedtofunctionwithoutdegradation

duringexposuretoalltestseveritiesperClass3.3.

ThisproductmeetsEURoHSDirective2002/95/ECand/orappli‐

cableexemptions.Refertowww.adtran.com

forfurtherinfor‐

mationonRoHS/WEEE.

ADTRAN 1442703PG2 Datasheet

Brand: ADTRAN

Model: 1442703PG2

Category: Network transceiver modules

Type: Datasheet

Download PDF

report

ADTRAN 1442703PG2 Datasheet

ADTRAN 1442703PG2 Datasheet

Related papers

Other documents