ADTRAN 1442701PG4 Datasheet

Brand: ADTRAN

Model: 1442701PG4

Category: Network transceiver modules

Type: Datasheet

This manual is also suitable for

1442701PG1

jobAid

DESCRIPTION

TheOC‐3SmallForm‐FactorPluggableCWDM,1471nm(SFP

OC3)plugsintoADTRANOC‐3equipmentdesignedtoaccept

SmallForm‐factorPluggables(SFPs).

Installedintoanappropriatehostunit,theSFPOC3providesan

OC‐3CWDMinterfacetothesupportingsystem.

NOTE

Toensurecompatibility,refertothedocumentationprovi ded

withthehostmodule.

The following features are supported on the SFP OC3:

♦ SONETOC‐3compatible(155.52Mb/s)1471nm,

longreach,single‐mode,2‐fiberoperation

♦ 80kmmaximumopticalspan

CAUTION

Duetocompliancecertificationrequirements,use on lySFPs

suppliedbyADTRANwiththehostmodule.ADTRANcannot

certifysystemintegritywithotherSFPs.

SPECIFICATIONS

♦ OpticalSpecifications:

◊ Opticaltransmitlevel:0dBmto–5dBm

◊ Opticalreceivelevel:–10dBmto–34dBm

◊ Powerpenalty:–1dB

◊ Opticalbudget:28(±1)dBm

◊ Minimumspanattenuation:10dB

◊ Opticalconnectors:LC

♦ ExtendedEnvironmentalSupport:

◊ Operationaltemperaturerange:–40°Cto+65°C

◊ Storagetemperaturerange:–40°Cto+85°C

◊ Relativehumidityto95%,noncondensing

OC-3 Small Form-Factor Pluggable

CWDM, 1471 nm

INSTALLATION

ToinstalltheSFPOC3intoanappropriatemodule,completethe

followingsteps:

1. InspecttheSFPOC3.Ifdamaged,fileaclaimwiththecar‐

rierandthencontactADTRANCustomerSupport.

CAUTION

DonotremovetheprotectiveendcapfromtheSFPuntilthefiber

opticcableisreadytobeconnected.

2. InserttheSFPOC3intotheSFPcageonthemodule.Ensure

thatthemanufacturer’slabelontheSFPisfacingupwardfor

correctinstallation.

3. SlidetheSFPOC3allthewayintothereceptacleuntilthere

isanaudible“click”.

NOTE

ThelatchontheSFPisusedtoremovetheSFPfromthecageon

thecircuitcard.

PROVISIONING

The SFPOC3 is not directly provisionable. To provision the

SFPOC3, access the menu system of the host module. Refer

to the “Provisioning” section of the Job Aid or I&M provided

with the host module for provisioning details.

SAFETY AND REGULATORY COMPLIANCE

CAUTION

ElectrostaticDi schar ge(ESD)candamageelectronicmodules.

Whenhandlingmodules,wearanantistaticdischargewriststrap

topreventdamagetoelectroniccom pon ents .Placemodulesin

antistaticpackingmaterialwhentranspo rtingorstoring.When

wor kin g on modules, always placethem on an approved

antistaticmatthatiselectricallygrounded.

TheSFPOC3isNRTLListedtotheapplicableULstandards.The

SFPOC3meetsorexceedsalltheapplicablerequirementsof

NEBS,TelcordiaGR‐63‐CORE,GR‐1089‐CORE,andETSIEN

300368.

TheSFPOC3isintendedfordeploymentinCentralOfficetype

facilities,EEEs,EECs,andlocationswheretheNECapplies(for

example,CustomerPremises).TheSFPOC3istobeinstalledin

ADTRANproductsinRestrictedAccessLocationsonly,and

installedbytrainedservicepersonnel.

CLEI: SITRAAFA_ _

Product P/N: 1442701PG1

Issue Date: November 2010

Document P/N: 61442701PG1-22C

C A U T I O N

SUBJECT TO ELECTROSTATIC DAMAGE

OR DECREASE IN RELIABILITY.

HANDLING PRECAUTIONS REQUIRED.

Warranty: ADTRAN will replace or repair this product within the warranty period if it does not

meet its published specifications or fails while in service. Warranty information can

be found online at www.adtran.com/warranty

ADTRAN CUSTOMER CARE:

From within the U.S. 1.800.726.8663

From outside the U.S. +1 256.963.8716

PRICING AND AVAILABILITY 1.800.827.0807

*61442701PG1-22C*

ThisdevicecomplieswithPart15oftheFCCrules.Operationis

subjecttothefollowingtwoconditions:

1. Thisdevicemaynotcauseharmfulinterference

2. Thisdevicemustacceptanyinterferencereceived,including

interferencethatmaycauseundesiredoperation.

ChangesormodificationsnotexpresslyapprovedbyADTRAN

couldvoidtheuserʹs

authoritytooperatethisequipment.

CAUTION

TheSFPOC3containsaClass1laserthatcomplieswiththeLaser

SafetyrequirementsofFDA21CFR1 040.10and1040.11,andEN

60825‐1,and‐2.TheSFPOC3isNRTLListedandCBCertifiedto

allapplicableAmericanandEuropeansafetystandards.

CAUTION

♦ PerGR‐1089‐CORESection9,theSFPOC3 does not have an

internal DC connection between battery return and

frame ground.

♦ TheADTRANsystemthattheSFPOC3isbeingdeployedinis

designedandinte ndedforins tall ationaspartofaCommon

BondingNetwork(CBN),orIsolatedBondingnetwork(IBN).

♦ TheSFPOC3canbeinstalledinaDC‐I(isolated)orDC‐C

(common)configuration.Forinstallationswher eothercards

orthehostsystemhaveinternalconnectionsbetweenbattery

returnandframeground,thesystemwouldbe intendedfor

deploymentonlyinaDC‐Cconfiguration.

♦ TheADTRANsystemchassis framegroundterminalmustbe

connectedtoareliableearth ground toensurethatthemetal

enclosureof theSFP OC3is pr operlygrounded vi athe

backplaneconnector.

NOTE

♦ TheOC‐3port(s)areopticalandthereforearenotclassifiedas

anytypeofportasdefinedinAppendixBofGR‐108 9‐CORE

Issue5.

♦ ThisSFPOC3iscompliantwithSFF‐8472“DigitalDiagnostics

MonitoringInterfaceforOpticalTransceivers,”Revision9.3.

♦ This SFPOC3 iscompliant with theSmall Form‐Factor

Pluggable(SFP)Multi‐SourceAgreement(MSA).

♦ Thi sproductisdesigned to bedeployedinGR‐3108‐CORE

environmentclass1or2asdefinedinGR‐3108‐COREissue2.

TheSFPOC3isdesignedtomeetthefollowingenvironmental

classes:

♦ ETSIEN300019‐1‐1“Classificationofenvironmental

conditions;Storage,”Class1.2

♦ ETSIEN300019‐1‐2“Classificationofenvironmental

conditions;Transportation,”Class2.3

♦ ETSIEN300019‐1‐3“Classificationofenvironmental

conditions;Stationaryuseatweather‐protectedlocations,”

Class3.3

♦ ETSIEN300386“ElectromagneticcompatibilityandRadio

spectrumMatters(ERM);Telecommunicationnetwork

equipment;ElectromagneticCompatibility(EMC)

requirements”

Theequipmentisdesignedtofunctionwithoutdegradation

duringexposuretoalltestseveritiesperClass3.3.

ThisproductmeetsEURoHSDirective2002/95/ECand/orappli‐

cableexemptions.Refertowww.adtran.com

forfurtherinfor‐

mationonRoHS/WEEE.

ADTRAN 1442701PG4 Datasheet

Brand: ADTRAN

Model: 1442701PG4

Category: Network transceiver modules

Type: Datasheet

This manual is also suitable for

1442701PG1

Download PDF

report

ADTRAN 1442701PG4 Datasheet

This manual is also suitable for

ADTRAN 1442701PG4 Datasheet

Related papers

Other documents